Adjusting rear sensors for larger bags.
It’s frustrating to upgrade the bags only to fight with your boat to fill them.
#1 you will need to upgrade / reinforce your engine panels. Perhaps even the rear access panels.
#2 purchase 2 check valves 32003-100 from Wakemakers ($17 ea) and 6 hose clamps size 16.
#3 you’ll need a heat gun. Everything else is done with basic tools.
This process will net you 6” higher sensors and prevent air from entering your bags when you drain them.
Remove both overflow assemblies. From the bags to the through hull fittings. https://uploads.tapatalk-cdn.com/202...05c041fcb8.jpg
Sent from my iPhone using Tapatalk
Adjusting rear sensors for larger bags.
https://uploads.tapatalk-cdn.com/202...d868e60fd4.jpg
Cut the long hose about 14” from the straight fitting that connects to the top of the sensor.
Remove the straight fitting from the short hose that went between the bag and the sensor. Use it on the 14” section pointed at.
You will need to heat the hose to get it over the barb on the fitting.
Sent from my iPhone using Tapatalk
Adjusting rear sensors for larger bags.
https://uploads.tapatalk-cdn.com/202...ab94d5ee2b.jpg
Install the check valve between the end of the short hose and the rest of the long hose that goes to the through hull fitting. You’ll need to cut off the end that was pressed on the fitting.
Make sure it lets air move the direction of the through hull end.
Sent from my iPhone using Tapatalk