Printable View
I pulled the drain bolt on my 2011 LSV a couple of weeks ago. I tried putting it back in today and it threaded, but seemed to strip or not tighten fully. Anybody have experience with this? I'm thinking I will pull the hoses off the muffler and see if I can see any issue internally. It didn't seem to get a good seal when I replaced it.
I've done this in the past without issue. Not sure what happened today. Thoughts?
Why didn’t you just disconnect the connector hoses between the exhaust manifolds?
Sent from my iPad using Tapatalk
The muffler drain bolt is threaded into the fiberglass body so I am always careful how much force I use when tightening it. The bolt has a rubber gasket to provide a seal. You could tap the hole to the next size bolt or use a metal roofing screw with a gasket.
Those things are a bear to get off. The drain bolt is there to make it easy.
I'm careful with it too, not sure what happened this time. I think I'll pull hose off on that side and see about tapping to a bigger size.Quote:
Originally Posted by VA LSV
This drain plug in the muffler always gets more water out of it after I disconnected the hose fittings prior.Quote:
Originally Posted by Stazi
Mine never really gets tight either. I just tighten it about a 1/3rd of a turn after the head/washer meets the muffler.