Tab Content
  • HFarr's Avatar
    Today, 08:19 PM
    HFarr replied to a thread Rough Water in General Chat
    Go slow. The Moombas/ surfboats are absolutely not good rough water boats. Some slight chop I have discovered trimming all the way down puts the...
    2 replies | 39 view(s)
  • HFarr's Avatar
    Today, 03:14 PM
    HFarr replied to a thread Cooler set up in General Chat
    There is a thread on here somewhere showing how they moved the batteries out of there, just forward I believe, and mounted a large plastic tote with...
    114 replies | 7127 view(s)
  • HFarr's Avatar
    Today, 11:46 AM
    If the two rear bags are only 1,000 each I guess that means the front bag is 2,000 lbs? Didn't think it was that big/heavy. Sent from my SM-G781V...
    48 replies | 3351 view(s)
  • HFarr's Avatar
    Yesterday, 08:50 PM
    HFarr replied to a thread Cooler set up in General Chat
    Hey that looks good! I did that for a bit with my yeti softside, but it didn't fit as well as yours does. That little tray and trash can they give...
    114 replies | 7127 view(s)
  • HFarr's Avatar
    Yesterday, 08:47 PM
    HFarr replied to a thread Cooler set up in General Chat
    Or down here in the warmer climates an 800# yamaha Grizzly 4x4 stuck in mud over the tires with a heat index of 110 and extreme humidity. Sent...
    114 replies | 7127 view(s)
  • HFarr's Avatar
    Yesterday, 08:44 PM
    Ahh...what he just said makes since. Sent from my SM-G781V using Tapatalk
    21 replies | 287 view(s)
  • HFarr's Avatar
    Yesterday, 08:42 PM
    I promise you that they are ballooning up with air if you don't bleed them. Just check next time. Sent from my SM-G781V using Tapatalk
    48 replies | 3351 view(s)
  • HFarr's Avatar
    Yesterday, 08:40 PM
    I don't have WM upgrade. I do see FatSac written on one end of them. Not sure if that's who Moomba used that year or not. I didn't order the boat....
    48 replies | 3351 view(s)
  • HFarr's Avatar
    Yesterday, 05:02 PM
    "Just because you can, doesn't mean you should". That's what Jeff Goldblum said on Jurassic park! LOL! I sometimes get like that too, and I think...
    22 replies | 184 view(s)
  • HFarr's Avatar
    Yesterday, 11:00 AM
    The 2021 Makai storage bins are 11" deep. Plus or minus thickness of the plastic. Sent from my SM-G781V using Tapatalk
    48 replies | 3351 view(s)
  • HFarr's Avatar
    05-23-2022, 07:49 PM
    You should let the dealer know about that "non existing pump" LOL! Sent from my SM-G781V using Tapatalk
    3 replies | 79 view(s)
  • HFarr's Avatar
    05-23-2022, 07:47 PM
    Yes on the flexing. That was my whole point earlier. Something has to move/pivot at that end too for it to work. I'm not crazy about flexing...
    21 replies | 287 view(s)
  • HFarr's Avatar
    05-23-2022, 07:43 PM
    HFarr replied to a thread Cooler set up in General Chat
    I guess you are right. I do have the 50+ covered though! And it's funny how every sit down or stand up is accompanied by a grunt of some sort! ...
    114 replies | 7127 view(s)
  • HFarr's Avatar
    05-23-2022, 06:24 PM
    HFarr replied to a thread Cooler set up in General Chat
    Oh I like that!!! It wouldn't be that terribly hard to do either. Is it practical? Not really. But the cool factor is there for sure. Sent from...
    114 replies | 7127 view(s)
  • HFarr's Avatar
    05-23-2022, 06:18 PM
    That's exactly what that extra tab does. Give it Yaw that is. I am sure welded tabs could create yaw. Some of the tab systems out there do have a...
    22 replies | 184 view(s)
  • HFarr's Avatar
    05-23-2022, 12:21 PM
    Autowake does some dark magic stuff, so I won't try to explain it. But, I do know that you have no control over the little secondary tabs on the...
    22 replies | 184 view(s)
  • HFarr's Avatar
    05-23-2022, 12:17 PM
    HFarr replied to a thread Cooler set up in General Chat
    Where you going to put the ice maker? Sent from my SM-G781V using Tapatalk
    114 replies | 7127 view(s)
  • HFarr's Avatar
    05-23-2022, 12:17 PM
    HFarr replied to a thread Cooler set up in General Chat
    That would probably fit fine. Sent from my SM-G781V using Tapatalk
    114 replies | 7127 view(s)
  • HFarr's Avatar
    05-22-2022, 10:08 PM
    HFarr replied to a thread Cooler set up in General Chat
    I also have a 21 makai Sent from my SM-G781V using Tapatalk
    114 replies | 7127 view(s)
  • HFarr's Avatar
    05-22-2022, 10:07 PM
    HFarr replied to a thread Cooler set up in General Chat
    I am thinking 17" might be too tall. I bought an AO 36 can cooler that is 36" long x 10" wide X 12" tall and it fits snug just under the seat. ...
    114 replies | 7127 view(s)
  • HFarr's Avatar
    05-22-2022, 05:23 PM
    Yep to what HMB said. Just think of it like your car or truck. Air won't get warm until the engine temp or coolant gets up there. Unless you have...
    14 replies | 2373 view(s)
  • HFarr's Avatar
    05-22-2022, 11:29 AM
    I bet they work fine. I bet the earlier comment where you said the tech told you the old ones had probably deformed over time is correct. The new...
    21 replies | 287 view(s)
  • HFarr's Avatar
    05-22-2022, 11:26 AM
    HFarr replied to a thread Bad Alternator? in Audio & Electrical
    Just search for electric motor repair shops. Or call some HVAC companies/electrical contractors and ask about them. Sent from my SM-G781V using...
    19 replies | 307 view(s)
  • HFarr's Avatar
    05-22-2022, 11:24 AM
    HFarr replied to a thread May 2022 pictures in General Chat
    Man I bet that was a blast! He will remember that and be stoked for going back again! Sent from my SM-G781V using Tapatalk
    81 replies | 3053 view(s)
  • HFarr's Avatar
    05-21-2022, 09:57 PM
    I opened the pdf and see what you mean now. Still don't like that design. Constantly flexing plastic will eventually fail. Not to mention it...
    21 replies | 287 view(s)
  • HFarr's Avatar
    05-21-2022, 09:00 PM
    Wow. That's really not a very good design. Sent from my SM-G781V using Tapatalk
    21 replies | 287 view(s)
  • HFarr's Avatar
    05-21-2022, 07:12 PM
    HFarr replied to a thread Bad Alternator? in Audio & Electrical
    Glad it is working without too much trouble. Now put it in the water and have some fun! Sent from my SM-G781V using Tapatalk
    19 replies | 307 view(s)
  • HFarr's Avatar
    05-21-2022, 06:50 PM
    Exactly. It has to either pivot or slide or it just won't work. The angle of the actuator has to be able to change as it moves. That's why the...
    21 replies | 287 view(s)
  • HFarr's Avatar
    05-21-2022, 11:28 AM
    HFarr replied to a thread May 2022 pictures in General Chat
    I like that paint scheme on that Mondo. Sent from my SM-G781V using Tapatalk
    81 replies | 3053 view(s)
  • HFarr's Avatar
    05-20-2022, 04:52 PM
    OR. Is there a sliding mechanism or slot that is on the end where it mounts to the wake plate? Sent from my SM-G781V using Tapatalk
    21 replies | 287 view(s)
More Activity
About HFarr

Basic Information

About HFarr
Location:
South Georgia
Occupation:
Facilities Director & Engineer

Signature


2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub

Statistics


Total Posts
Total Posts
1,050
Posts Per Day
2.40
General Information
Last Activity
Today 08:20 PM
Join Date
03-15-2021
Referrals
0