Register
Help
Remember Me?
Forum
New Posts
FAQ
Calendar
Community
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
What's New?
Advanced Search
Member List
Holdmybeer
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Holdmybeer
Senior Member
Find latest posts
Find latest started threads
Mini Statistics
Join Date
01-18-2021
Last Activity
Yesterday
05:03 PM
Avatar
Recent Visitors
The last 10 visitor(s) to this page were:
996scott
,
bcharles24
,
hammrd2024
,
JJ Boost
,
Mxmark4
,
Ncatlin01
,
privyan
,
stitch_99
,
tehnoobshow
,
zsophishulzeo9163
This page has had
156,478
visits
Tab Content
Holdmybeer's Activity
About Me
Tab Content
All
Holdmybeer
Friends
Photos
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
03-23-2025,
03:37 PM
Holdmybeer
replied to a thread
MOJO ate an idler pulley
in
Service & Repair
That was the part number I used for the pulley. I have a local-ish Indmar dealer that ordered both the pulley and the belt for me. Check...
see more
21 replies | 5633 view(s)
03-21-2025,
09:58 PM
Holdmybeer
replied to a thread
MOJO ate an idler pulley
in
Service & Repair
This the pulley that failed on me. The bearing seized and the belt ate the plastic.
see more
21 replies | 5633 view(s)
03-21-2025,
09:57 PM
Holdmybeer
replied to a thread
MOJO ate an idler pulley
in
Service & Repair
The half inch drive goes in the square hole on the right. My ratchet did not give me enough leverage. I used a 24" breaker bar and it was easy.
see more
21 replies | 5633 view(s)
03-18-2025,
09:25 AM
Holdmybeer
replied to a thread
Trailer Brake Bleed
in
Service & Repair
If you have an oil extractor for your boat already just it. You can have someone putting fluid in as you pump the extractor. Next time anyone...
see more
6 replies | 3868 view(s)
03-18-2025,
09:19 AM
Holdmybeer
replied to a thread
MOJO ate an idler pulley
in
Service & Repair
Yep. 3 bolts, hub on pump pulls back just enough to run the flat belt through. Bolt pump back to balancer. The bolts completely suck to remove. ...
see more
21 replies | 5633 view(s)
03-12-2025,
04:31 PM
Holdmybeer
replied to a thread
Checking in and saying hi!
in
General Chat
Are the southern states starting to get boats out yet? We are have 70* weather in Ohio and I know it will snow again so I'm trying to suppress my...
see more
46 replies | 46963 view(s)
03-12-2025,
04:29 PM
Holdmybeer
replied to a thread
Full Re-Upholstery Costs
in
General Chat
Everytime I have thought about doing this, my next thought is shopping for new/used boats. I don't have the patience for upholstery.
see more
9 replies | 7092 view(s)
03-01-2025,
12:40 PM
Holdmybeer
replied to a thread
2016 Raptor 6.2 error codes
in
Service & Repair
It appears to be a post CAT O2 fault. Mostly caused from water on the sensor. I doubt the catalyst went bad unless you flooded your bilge or had...
see more
10 replies | 12781 view(s)
02-26-2025,
10:31 PM
Holdmybeer
replied to a thread
2005 Moomba Mobius XLV ECM fried
in
General Chat
Not sure why a complete rewire is needed. Wire harness is marine quality (aka built for water). Unplug everything, use dryer fans for a couple...
see more
5 replies | 5296 view(s)
More Activity
No More Results
No Recent Activity
About Holdmybeer
Basic Information
About Holdmybeer
Location:
Columbus, Ohio
Signature
2015 Moomba Mojo Surf Edition
4,000lbs
Manual Flow
Statistics
Total Posts
Total Posts
1,381
Posts Per Day
0.90
General Information
Last Activity
Yesterday
05:03 PM
Join Date
01-18-2021
Referrals
0