Holdmybeer
Senior Member

How is water depth at the other 3 in late June - July? I know Norris is 80-300ft deep. Safe to assume the other 3 are similar? We boat in...

When you say "locks up" is the motor vapor locking of so flooded it physically has too much gas in the cylinder bore? Vapor lock I understand. ...

What year? Skiers stops making replacements after 5-7yrs so based on age you might have to find a local shop.

I have a 2015 Mojo. It is tight but being 23ft long everything is a little stretched out. I had about 8" from driplees seal to coupler. The...

If you need help, reach out. Never broke a shaft but did have to remove everything you are to replace my dripless. Tim @ Glide helped me get...

Fantastic. I'm sure the dropstep, thrusters, e-pex tower, etc. all add extra weight also. 10k+ weight all full then add gear, fuel and people

The added weight is impressive on the Max. I was hoping to see this on the Mojo and Makai also. However, seeing the dropstep come to the Moomba line...

I can fix this for you. I had the same issue and had to MacGyver it on the water. From the top of the coolant reservior there is a small 1/4"...

If the v-drive is over filled, when it gets hot or under heavy load, the fluid can burp out of the vent on top. It's painted black and it a metal...

I see you did the right thing. Just drink a beer, laugh, and tackle 1 problem at a time. Not worth ruining good memories over a bad attitude. ...

V-Drive reservoir? You mean the case is cracked? The v-drive and fluids are all self contained. Do you have pictures so we can try to help?

My 2015 is keyed at the coupler. Not sure how you could mess it up and not get it to align back to design.

This is your choice, but I'm marking the shaft and coupler with a sharpie and separating. No way I would pull the tank for this. The new...

I went with Glide dripless

You shouldn't have to pull the vdrive on the tank. Unbolt the coupler and save for re-install. Loosen and disconnect your packing seal - I...

Rather have thruster for that coin!

Banks has the best solution but it's expensive. Replaces the whole intake elbow. Berg once you do this the only issues would be VGT accuator and...

Berg, Turning wrenches yourself is a good bet but you will need a tune or old school tuner to get your engine light off. There are some "race"...

6.7 cummins. 2014 so you have the grid heater also. The mounting bolt of the grid heater can break off after time and kill an engine. Yours isn't...