Register
Help
Remember Me?
Forum
New Posts
FAQ
Calendar
Community
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
What's New?
Advanced Search
Member List
Holdmybeer
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Holdmybeer
Senior Member
Find latest posts
Find latest started threads
Mini Statistics
Join Date
01-18-2021
Last Activity
Today
04:41 PM
Avatar
Recent Visitors
The last 10 visitor(s) to this page were:
996scott
,
Buckeye
,
hammrd2024
,
JJ Boost
,
kaxray
,
mgswake
,
Ncatlin01
,
Peter76
,
stitch_99
,
tehnoobshow
This page has had
485,545
visits
Tab Content
Holdmybeer's Activity
About Me
Tab Content
All
Holdmybeer
Friends
Photos
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Yesterday,
03:34 PM
Holdmybeer
replied to a thread
Indmar 400 Thermostat
in
General Chat
You figure you run these engines at 3200rpm or higher for hours at a time. In the truck, at cruise speed, the transmission would drop to overdrive...
see more
19 replies | 92656 view(s)
Yesterday,
12:22 PM
Holdmybeer
replied to a thread
Indmar 400 Thermostat
in
General Chat
It's the same 160* thermostat for a 6.2 ford 150 raptor truck. There is not a marine version. Also, check your idler pulley. Mine locked up and...
see more
19 replies | 92656 view(s)
Yesterday,
12:20 PM
Holdmybeer
replied to a thread
2022 Mondo ballast fill issues
in
Service & Repair
Your fill sensors need reset and/or calibrated. You are over filling and the sensors are not shutting them off. My 2015 didn't have these and you...
see more
1 replies | 53 view(s)
Yesterday,
12:16 PM
Holdmybeer
replied to a thread
Intermittent scraping noise coming from engine
in
Service & Repair
If it is random and happens at any engine condition, then most likely not engine related. When did you last replace your raw water impeller? Hard...
see more
4 replies | 74 view(s)
08-06-2026,
07:02 AM
Holdmybeer
replied to a thread
Surf tabs won’t wake up ( pun intended!)
in
WakeSurfing
Try this. Shut it down and turn off the battery switch and let sit for 10 minutes. Turn battery switch to 1 or 2 not both. (My 2015 I would...
see more
5 replies | 667 view(s)
08-02-2026,
05:21 PM
Holdmybeer
replied to a thread
Surf tabs won’t wake up ( pun intended!)
in
WakeSurfing
Being the the forum long enough, I believe several have had this problem. Dealer trip for firmware update and all was good again.
see more
5 replies | 667 view(s)
08-02-2026,
05:19 PM
Holdmybeer
replied to a thread
July 2026 Picture Thread
in
General Chat
Our old 2015 Mojo was so small parked side by side. It feels bigger when driving also but so much smoother. Going from old surf system and 3...
see more
5 replies | 631 view(s)
07-31-2026,
06:58 PM
Holdmybeer
replied to a thread
July 2026 Picture Thread
in
General Chat
Since you started the thread, I figure I would reveal my new ride. 2025 Mojo. Thrusters, fat guy step, etc. Only option I didn't get was the power...
see more
5 replies | 631 view(s)
07-15-2026,
01:56 PM
Holdmybeer
replied to a thread
Engine rattle
in
Service & Repair
I would back it off slightly. I assume you don't have a tensioner like a car engine or the newer boats. The alternator is adjustable to tighten the...
see more
9 replies | 6371 view(s)
07-14-2026,
10:31 AM
Holdmybeer
replied to a thread
Moomba Mojo Dual Screen Aux Input?
in
Audio & Electrical
I believe there is one on the side by the cup holders. 12v socket is there and a bunch of USB-C ports on my 2025. I thought one of them was a 3.5mm...
see more
1 replies | 4295 view(s)
More Activity
No More Results
No Recent Activity
About Holdmybeer
Basic Information
About Holdmybeer
Location:
Columbus, Ohio
Signature
2015 Moomba Mojo Surf Edition - SOLD
4,000lbs
Manual Flow
2025 Mojo - Incoming
Statistics
Total Posts
Total Posts
1,465
Posts Per Day
0.72
General Information
Last Activity
Today
04:41 PM
Join Date
01-18-2021
Referrals
0