Tab Content
  • mmandley's Avatar
    Yesterday, 05:14 PM
    mmandley replied to a thread fogging raptor motor in General Chat
    Fogging is just to protect the cylinders from pitting causes by moisture in the cylinders. That's why if you just start the engine periodically...
    20 replies | 343 view(s)
  • mmandley's Avatar
    Yesterday, 04:02 PM
    mmandley replied to a thread fogging raptor motor in General Chat
    And that's fine just saying it's really not needed, divas you wish I was just giving you my experience with engines for 30+ years. Sent...
    20 replies | 343 view(s)
  • mmandley's Avatar
    Yesterday, 01:26 PM
    mmandley replied to a thread fogging raptor motor in General Chat
    Why are you fogging at all You realize when you start the engine next season you will burn that through the cats. I've never fogged my boats...
    20 replies | 343 view(s)
  • mmandley's Avatar
    09-18-2017, 07:49 AM
    mmandley replied to a thread Seal coming off in Service & Repair
    Just extra silicone, you can rub it off or use a sharp plastic blade to remove it. That's all the dealer is going to do. Sent from my...
    7 replies | 214 view(s)
  • mmandley's Avatar
    09-11-2017, 02:17 PM
    I have the Leaf and it does squeak more then torsion. Only thing you can do is lube the rubber inserts for the springs to the mounting shackles.
    4 replies | 219 view(s)
  • mmandley's Avatar
    09-11-2017, 02:12 PM
    Correct I did it and I did the Wave Makers Wave Control. I went from no Flow control device, to the Manual Flow, to the WM Wave Control. I...
    7 replies | 360 view(s)
  • mmandley's Avatar
    08-31-2017, 03:29 PM
    It's stupid crazy living on one the largest lake in GA and I have a whooping 25hrs lol I've literally used 2.5 tanks of fuel lol Between...
    41 replies | 1167 view(s)
  • moombadaze's Avatar
    08-31-2017, 10:27 AM
    moombadaze replied to a thread Hurricane Harvey in Off Topic
    so much destuction, some of the photos are just hard to fathom. Prayers to all dealing with this. and for Heidi-one of many out of sight hero's-cant...
    31 replies | 1682 view(s)
  • mmandley's Avatar
    08-30-2017, 01:50 PM
    It could be a loose ground at your gauge or loose connection at your sending unit. Normally low oil pressure is all the time or mor consistent at...
    1 replies | 154 view(s)
  • mmandley's Avatar
    08-29-2017, 09:17 AM
    mmandley replied to a thread Nada values in General Chat
    If your buying from him then make the deal so what ever money you want on your old boat is taken off the new boat price. Then essentially your...
    7 replies | 454 view(s)
  • mmandley's Avatar
    08-29-2017, 09:15 AM
    mmandley replied to a thread Nada values in General Chat
    Dealer is probably using a different version Every time I buy a truck I go through what your going through. Dealer is always going to use the...
    7 replies | 454 view(s)
  • mmandley's Avatar
    08-27-2017, 07:52 PM
    mmandley replied to a thread Nada values in General Chat
    The low retail is to give you an idea what you should get. Trade in is exactly that, you have to leave meat on the bone for the dealer. No...
    7 replies | 454 view(s)
  • mmandley's Avatar
    08-25-2017, 12:57 PM
    mmandley started a thread Bilge Pump in Service & Repair
    I've been fighting with my bilge pump all winter it seems Sometimes it works, other times it doesn't. Sometimes it has low flow pressure...
    0 replies | 110 view(s)
  • mmandley's Avatar
    08-25-2017, 12:49 PM
    mmandley replied to a thread Trans Clunk in General Chat
    There will be an engagement clunk but it's a very solid low type of noise Deff check coupler, drive bolts, also check engine mounts, trans mount...
    4 replies | 176 view(s)
  • mmandley's Avatar
    08-24-2017, 04:37 PM
    Them Raptor engines, lots different on them lol Sent from my iPhone using Tapatalk
    8 replies | 278 view(s)
  • mmandley's Avatar
    08-24-2017, 02:00 PM
    mmandley replied to a thread White Smoke in General Chat
    Catalytic converters don't block everything they are only to protect the environment not people Carbon Monoxide is very real behind boats even...
    8 replies | 289 view(s)
  • mmandley's Avatar
    08-21-2017, 02:43 PM
    I wasn't aware it was electric. None the less you can follow the fresh water intake hose to find the impeller housing. Sent from my iPhone...
    8 replies | 278 view(s)
  • mmandley's Avatar
    08-21-2017, 02:15 PM
    Lol smoking dogs lol Sent from my iPhone using Tapatalk
    8 replies | 278 view(s)
  • mmandley's Avatar
    08-21-2017, 01:45 PM
    You should be able to just follow the cold water intake It's belt driven You should only have alternator, water pump (closed cooling) and...
    8 replies | 278 view(s)
  • mmandley's Avatar
    08-21-2017, 01:26 PM
    I would be looking at your throttle neutral switch It's prolly internal short tripped breaker that's why it worked that time. Sent from my...
    6 replies | 273 view(s)
  • mmandley's Avatar
    08-21-2017, 01:22 PM
    Those look like the correct 15 up brackets but you need the boat hull side bracket Sent from my iPhone using Tapatalk
    10 replies | 479 view(s)
No More Results

4 Visitor Messages

  1. View Conversation
    Viking - Hello - just wanted to thank you for the picture of the water strainer mounting location. I purchased the strainer from SkiDIM and mounted it recently. We have about 8 hours on the boat so far this season using the strianer and I am amazed at teh "crap" that gets in there from the river. Thanks again - if your ever in western PA - you go a ride. Mike
  2. View Conversation
    Hey Viking,

    I have an '07 outback as well. Do you know if there is any way to hook up an ipod to the stock stereo? I looked for an RCA input on the back but couldn't find anything. I have the Aeware remote by the driver and on the back of the hull so I'm afraid of buying a new stereo that may not be compatible.
  3. View Conversation
    That is also a great board for the boat the shape of the boards is the same but the flex is different the more flex (reflex) the more you feel of choppy water under it and the less pop off the wake ! Watch zucky on youtube
  4. View Conversation
    Iff I can give you advise do no go for the slingshot reflex board it is great for sliders and cable boarding but not so great behind the boat!! Try to test it before you buy!!
Showing Visitor Messages 1 to 4 of 4
About viking

Basic Information

About viking
Biography:
Work to Play on the Water
Location:
Montana
Interests:
boating (of course)

Signature



2007 Moomba Outback - going, going, GONE
2015 "NOT A MOOMBA"

Why Not? Play Hard! Get wet

Statistics


Total Posts
Total Posts
3,061
Posts Per Day
1.04
Visitor Messages
Total Messages
4
Most Recent Message
06-01-2012 12:43 PM
General Information
Join Date
08-30-2009
Referrals
1

9 Friends

  1. AusFire AusFire is offline

    Member

    AusFire
  2. Hydrofoiljunky Hydrofoiljunky is offline

    Senior Member

    Hydrofoiljunky
  3. jimmobius jimmobius is offline

    Senior Member

    jimmobius
  4. KurtL KurtL is offline

    Senior Member

    KurtL
  5. mmandley mmandley is offline

    Super Moderator

    • Send a message via Yahoo to mmandley
    mmandley
  6. moombadaze moombadaze is offline

    Super Moderator

    moombadaze
  7. newty newty is offline

    Senior Member

    newty
  8. Razzman Razzman is offline

    Senior Member

    Razzman
  9. zegm zegm is offline

    Senior Member

    zegm
Showing Friends 1 to 9 of 9