Tab Content
  • haknslash's Avatar
    Today, 08:43 AM
    haknslash replied to a thread 2021 max in General Chat
    The real question will be after you set it up how you like it...how long until you sell it and buy another boat? :D
    54 replies | 1181 view(s)
  • haknslash's Avatar
    Today, 08:39 AM
    :-D :D I hear ya!
    80 replies | 2785 view(s)
  • haknslash's Avatar
    Today, 06:56 AM
    haknslash replied to a thread 2021 max in General Chat
    I fully expect his Max to be massively weighted and throwing beastly waves. Can’t wait to see it all unfold.
    54 replies | 1181 view(s)
  • haknslash's Avatar
    Yesterday, 11:55 PM
    Yes your dealer can put you in touch with I want you I say her name was Cindy at a Skiers Choice or the dealer will handle the email traffic. They...
    2 replies | 59 view(s)
  • haknslash's Avatar
    Yesterday, 10:03 PM
    haknslash replied to a thread Fluid leak? in General Chat
    Reminds me of Ghostbusters II. Like mentioned only two sources for a red/pink liquid on these boats I think. Not sure if the pink coolant has that...
    8 replies | 128 view(s)
  • haknslash's Avatar
    Yesterday, 09:46 PM
    Dang is there anything Zandar can't do?!!? I still don't have the cajones to try something like that with the big ole Max! I need to step up my...
    80 replies | 2785 view(s)
  • haknslash's Avatar
    Yesterday, 09:29 PM
    haknslash replied to a thread Boat fenders in General Chat
    We rarely tie up with other boats too since I had tower damage on my last boat from board racks slamming into it thanks to a guy pulling tubes into a...
    21 replies | 2001 view(s)
  • haknslash's Avatar
    Yesterday, 07:27 PM
    haknslash replied to a thread Boat fenders in General Chat
    IMO Mission fenders don't offer a lot of protection, especially if it's rough or tying up to other boats. The whole point of a fender is to create...
    21 replies | 2001 view(s)
  • haknslash's Avatar
    Yesterday, 01:24 PM
    The first ones they sent to me were too short. Bryan has told me it was from an employee that wasn’t making them correctly and they had pulled...
    62 replies | 4989 view(s)
  • haknslash's Avatar
    08-09-2020, 06:09 PM
    You should be able to rotate the pic on your phone and then post it on imgur or another host so we can see full size. Too hard to tell from that pic.
    10 replies | 350 view(s)
  • haknslash's Avatar
    08-09-2020, 05:59 PM
    Mine has even held in the fine sand of Florida gulf on stiff windy days with my previous boat while Bimini was deployed. Small box anchor has been...
    18 replies | 352 view(s)
  • haknslash's Avatar
    08-09-2020, 12:31 PM
    Here is a second video I made of docking using a different approach angle and slight cross breeze plus having to place the boat in between two metal...
    18 replies | 352 view(s)
  • haknslash's Avatar
    08-09-2020, 12:28 PM
    Congrats on the Max! We came from a Yamaha after owning it for 2.5 years and you will love the v-drive for water sports over a jet by far!! We used...
    18 replies | 352 view(s)
  • haknslash's Avatar
    08-07-2020, 05:12 PM
    haknslash replied to a thread 2021 max in General Chat
    VERY interested in your custom Sewlong bimini!!! Please keep us in the loop on that project. My guess is you're going for larger bimini for increased...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 01:47 PM
    haknslash replied to a thread 2021 max in General Chat
    I also was speaking with Bryan lol and he is the one who handled the issues I ran into. Not once but twice on their bags (they sent me mismatched...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 01:18 PM
    haknslash replied to a thread 2021 max in General Chat
    They changed them in 2019 when Skiers Choice changed the overflow from top to bottom of the bag. They were pulled off the WM website as they retooled...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 12:01 PM
    haknslash replied to a thread 2021 max in General Chat
    It's also worth mentioning that my 15" ball statement may not be entirely accurate as my Exile balls are not filled to maximum inflation levels. They...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 11:55 AM
    haknslash replied to a thread 2021 max in General Chat
    I ordered my 2019 kit during Black Friday last year. Installed them in the spring of this year. They made me new replacement bags this year because...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 11:44 AM
    haknslash replied to a thread 2021 max in General Chat
    They use the same rear bags as the Makai which are 1,345 lb bags. I know the image they use for the Max bag buster says 1,200 lb but when you get the...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 11:22 AM
    haknslash replied to a thread 2021 max in General Chat
    Ditto what Dakota saying. With the WM rears I still have plenty of rear storage space even with bags full and rock hard. I keep my Exile balls in...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 11:16 AM
    haknslash replied to a thread 2021 max in General Chat
    Yea I would not get the side storage bins if you want to upgrade midship bags. The bins were an option last year as well. We still use our side...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 11:12 AM
    Yes the light gray shoes EVERYTHING! I would go darker next time. My vinyl gets wayyyy hotter than my gstorstep.
    17 replies | 278 view(s)
  • haknslash's Avatar
    08-07-2020, 11:08 AM
    haknslash replied to a thread 2021 max in General Chat
    I thought you could get the false floor last year if you optioned for the 4K ballast. Are you saying the 2021 Max is more like a big Enzo bag instead...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 11:04 AM
    haknslash replied to a thread 2021 max in General Chat
    The Wakemakers read bags are 1,340 lbs versus the 1,000 lb stock rear bags. The Wakemakers midship bags are 540 vs 500 stock respectively. In the end...
    54 replies | 1181 view(s)
  • haknslash's Avatar
    08-07-2020, 10:25 AM
    Is it possible to retrofit the 3.0 tabs and actuators on a 2.0 flow boat?
    24 replies | 502 view(s)
  • haknslash's Avatar
    08-07-2020, 10:22 AM
    Thanks and yea I few times I shot up to the back of that boat almost slamming into the swim deck lol. Had to bury the nose to keep from hitting it...
    80 replies | 2785 view(s)
  • haknslash's Avatar
    08-06-2020, 09:20 PM
    Here is some compiled gopro footage from our mini vacation on Martin.
    80 replies | 2785 view(s)
  • haknslash's Avatar
    08-05-2020, 11:30 PM
    I towed all last year with the cover on and never an issue. I just made sure it was very tight so it wouldn't flap around. The advantages of the...
    37 replies | 1113 view(s)
  • haknslash's Avatar
    08-05-2020, 11:22 PM
    You could buy some fly high plugs and connector that will work with tsunami pump on wakemakers.
    21 replies | 528 view(s)
  • haknslash's Avatar
    08-05-2020, 10:51 PM
    Awesome Zander. I love watching his vids and you can tell he has such desire and determination. Great job guys!!
    80 replies | 2785 view(s)
More Activity
About haknslash

Basic Information

About haknslash
Location:
Boating on Lake Martin, AL
Interests:
Surfing, enjoying family time
Occupation:
Product Design Engineer

Signature


2019 Moomba Max "MOOMBAE"
Mods: Wakemakers Bag Buster upgrade
2016 Yamaha AR192 - sold

Statistics


Total Posts
Total Posts
785
Posts Per Day
0.87
General Information
Last Activity
Today 08:43 AM
Join Date
02-16-2018
Referrals
0