Tab Content
  • haknslash's Avatar
    Yesterday, 11:02 PM
    If it’s that close to the bulkhead then I think they’re correct. My first bags were much, much shorter.
    74 replies | 2023 view(s)
  • haknslash's Avatar
    Yesterday, 04:37 PM
    Cool vid. I like the spray battle :D
    129 replies | 4843 view(s)
  • haknslash's Avatar
    Yesterday, 06:11 AM
    haknslash replied to a thread 2023 Max Build ?'s in General Chat
    I’ve heard for 2023 the 7” screen will become standard. The builder won’t reflect that of course but your dealer should be able to tell you what is...
    8 replies | 125 view(s)
  • haknslash's Avatar
    06-24-2022, 08:48 PM
    I don’t think he has the midnight flake on the rear so you’re safe Larry :D Loved the boat! My dealer is wanting me to put in a build slot for an...
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-23-2022, 01:35 PM
    Sorry I’m late to the party on this thread but they gave you the wrong bags. They gave you the same wrong bags I got for my Max when I got the WM...
    74 replies | 2023 view(s)
  • haknslash's Avatar
    06-22-2022, 10:13 PM
    haknslash replied to a thread 2023 Supra Models in General Chat
    I’ve noticed less traffic as well the few times we’ve been out this season. Still fairly crowded but nowhere near 2020 or 2021 amount of boaters.
    56 replies | 1527 view(s)
  • haknslash's Avatar
    06-22-2022, 05:52 PM
    haknslash replied to a thread 2023 Supra Models in General Chat
    Yes quotes are for 2022 build sheet with an $18k 2023 price increase line item tacked on. I don’t think my dealer has updated their spec sheet to say...
    56 replies | 1527 view(s)
  • haknslash's Avatar
    06-22-2022, 01:55 PM
    haknslash replied to a thread 2023 Supra Models in General Chat
    I’m not seeing over 200k quotes for 2023 SA or SL from my dealer. What specs are y’all seeing these builds at? Even if I opt for 450 engine,...
    56 replies | 1527 view(s)
  • haknslash's Avatar
    06-21-2022, 02:32 PM
    It’s the 56” Matrix. Yea I’ve seen some horror posts of folks with cuts on their forehead and body so I try to keep that in mind. On one of those...
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-21-2022, 05:58 AM
    Thanks, glad you liked it. I was running 11.6 mph for most of the vid :)
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-20-2022, 10:26 PM
    Those tubing flying pics are great! Many headaches were had when we were young and on tubes. I don’t miss being a rag doll but the pics and vid’s are...
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-19-2022, 11:25 PM
    Some fun and wipeouts today. Hope all you dads had a great day with your fam.
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-19-2022, 08:30 PM
    haknslash replied to a thread Squeal sound in Service & Repair
    Well we took the boat out all day and no strange sounds. Maybe it was just a freak occurrence. Boat ran and sounded great all day. The shaft seal...
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-19-2022, 07:15 AM
    Wife keeps saying not another boat when I bring it up lol. I’m slowly working on here. There are signs of life because when I got home yesterday from...
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-18-2022, 08:50 PM
    Picked up the boat from dealer service and took a demo on a 2022 SA450. Amazing boat all around. Also took a demo on a skim style board and brought...
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-17-2022, 05:28 PM
    haknslash replied to a thread Squeal sound in Service & Repair
    Is there a recommended grease that won’t have any adverse effects on the rubber? I don’t want to create a bigger problem down the road with...
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-17-2022, 01:06 PM
    haknslash replied to a thread Squeal sound in Service & Repair
    Gotcha. I’ll try and dig into this more once I’m at the dealer. Maybe I can grease it while I’m there.
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-17-2022, 01:05 PM
    haknslash replied to a thread Squeal sound in Service & Repair
    I can’t recall if I tested for the sound in reverse. It was only at idle speeds in forward from what I could remember and the dealer did mention prop...
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-17-2022, 06:55 AM
    haknslash replied to a thread Squeal sound in Service & Repair
    So I just need to loosen the clamps holding the seal to the shaft and then run some grease on the inside of it with my fingers? Anyone got a video...
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-17-2022, 05:39 AM
    haknslash replied to a thread Squeal sound in Service & Repair
    Is there a zerk fitting to use for greasing it? I didn’t realize this was a maintenance item and has to be greased periodicsllly. I wonder if my...
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-16-2022, 07:10 PM
    haknslash replied to a thread Squeal sound in Service & Repair
    Apparently so. He said it can be a harmonic sound from the shaft or prop spinning. Idk this is my first vdrive.
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-16-2022, 06:52 PM
    haknslash replied to a thread Squeal sound in Service & Repair
    I heard back from the dealer today and they said the sounds were normal sounds they’ve heard from other boats and didn’t see any issues. To me the...
    32 replies | 835 view(s)
  • haknslash's Avatar
    06-14-2022, 06:53 PM
    We didn’t option with a transom remote mainly because of the complaints you mentioned. I found more negative complaints about it than good so figured...
    11 replies | 419 view(s)
  • haknslash's Avatar
    06-12-2022, 04:11 PM
    The surging and the fact you said it wouldn’t go over 17 mph when you pushed the throttle makes me think you had your cruise turned on and didn’t...
    11 replies | 408 view(s)
  • haknslash's Avatar
    06-12-2022, 04:10 PM
    You could bump the kill switch. It kills the engine either by pushing the button or pulling the lanyard. Not ideal, I know, but it would work. On...
    2 replies | 133 view(s)
  • haknslash's Avatar
    06-12-2022, 11:53 AM
    Nah those were pics from last weekend ;). Boat is still at the shop but they’re going to look at it next week.
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-12-2022, 09:23 AM
    Ah yea it’s been a minute since I watched it :D I wouldn’t mind spending the money to go see the new one. I haven’t been to a movie theater in...
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-11-2022, 10:13 PM
    HAH! My landing would have looked as rough as Merlin’s did if I had tried it. I was FLYING down the top of the wave and had to abort :D
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-11-2022, 03:04 PM
    Hitting the brakes like Maverick in Top Gun :D
    129 replies | 4843 view(s)
  • haknslash's Avatar
    06-11-2022, 01:50 PM
    129 replies | 4843 view(s)
More Activity
About haknslash

Basic Information

About haknslash
Location:
Boating on Lake Martin, AL
Interests:
Surfing, enjoying family time
Occupation:
Product Design Engineer

Signature


2019 Moomba Max "MOOMBAE"
Mods: Wakemakers upgrade + 500 lbs of lead
2016 Yamaha AR192 - sold

Statistics


Total Posts
Total Posts
1,327
Posts Per Day
0.83
Visitor Messages
Total Messages
1
Most Recent Message
09-18-2020 02:09 AM
General Information
Last Activity
Yesterday 11:03 PM
Join Date
02-16-2018
Referrals
0

1 Friend

  1. gphrph gphrph is offline

    Junior Member

    gphrph
Showing Friends 1 to 1 of 1