Tab Content
  • KnoxMojo's Avatar
    08-23-2019, 02:25 PM
    KnoxMojo replied to a thread 2015 Moomba Mondo in General Chat
    I may know of an 18 Mondo with super low hours for sale by owner in Knoxville. Pretty sure $65k could buy it.
    10 replies | 137 view(s)
  • KnoxMojo's Avatar
    08-22-2019, 04:48 PM
    KnoxMojo replied to a thread Ballast Pump in Service & Repair
    If it's a jabsco pump with impeller, replace impeller. Should be a green ballast puppy. You could pull the plate and look as well.
    2 replies | 44 view(s)
  • KnoxMojo's Avatar
    08-22-2019, 01:38 PM
    KnoxMojo replied to a thread Props in Service & Repair
    Longer shaft or different angle
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-22-2019, 06:27 AM
    I know of a decked out 18 SA 400 that might be for sale for right at $100k
    19 replies | 413 view(s)
  • KnoxMojo's Avatar
    08-21-2019, 12:44 PM
    KnoxMojo replied to a thread Props in Service & Repair
    The blower motor for 2020 is still 1.5.. the rest of the 20s are 1.76.. only 19s with 1.76 are the later 450s. All 18 and below are 1.5.
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-21-2019, 11:26 AM
    KnoxMojo replied to a thread Props in Service & Repair
    Go ahead, let me know how that prop burn treats ya... I'll listen to the engineers at Skiers Choice that I personally know and Eric at over at OJ...0...
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 11:29 PM
    KnoxMojo replied to a thread Props in Service & Repair
    Not all Supra boats can run a 16" prop. The 1.5-1 transmission tops out at 15". The newer 1.76-1 can run a 16". The 550 engine is still 1.5-1 at this...
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 01:15 PM
    That's my guess.. where are you located? You may be running too much tab as.. try it at like 90, then work your way down to 25, upper end and lower...
    28 replies | 652 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 01:02 PM
    Ah, 1100 each side.. got ya.. yeah, you have a setup issue somewhere. You should be able to configure all that to ride with 2 people, driver and...
    28 replies | 652 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 12:13 PM
    That only adds up to 4500 pounds.. what am I missing... at some point it's also some technique and maybe needing a slightly bigger board.
    28 replies | 652 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 11:56 AM
    KnoxMojo replied to a thread Props in Service & Repair
    That's your choice to not like them. I know Eric personally and he does a phenomenal job. Their designs have come a long way and they've been great...
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 11:24 AM
    What's your pitch and roll numbers with that setup? 9.5 and -4 is what you should be looking for and maybe speed up a bit. That will firm up your...
    28 replies | 652 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 11:21 AM
    KnoxMojo replied to a thread Props in Service & Repair
    Pretty sure it's a 15x12 or 15x12.5.
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-20-2019, 11:20 AM
    KnoxMojo replied to a thread Props in Service & Repair
    OJ props aren't crappy, it just wasn't the right prop for your application.
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 10:37 PM
    KnoxMojo replied to a thread Props in Service & Repair
    Right on, I would get something bigger than the 1433..maybe find someone selling their stock OJ 14.25x14.5, but the ACME 1235 would perform very well...
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 10:02 PM
    KnoxMojo replied to a thread Props in Service & Repair
    You could probably go to the ACME 1235 and be really happy, as well as a 15x13 or 15x14....if you decide to sell the 15x12.5, I could put it to use...
    35 replies | 464 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 09:18 PM
    I think you have it pretty much covered. Set the surf plates pretty much the same as your Mondo, 65-70 for regular and 75 goofy. That 650 bag should...
    38 replies | 747 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 09:06 PM
    I agree, just 0 dealer support in my area. That 3' of draft is also a concern for me. Plus the wake for boarding is pretty meh.The dash looks like an...
    38 replies | 747 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 09:02 PM
    KnoxMojo replied to a thread Dealers trade boats? in General Chat
    Never hurts to ask. They want to sell boats, not have them sit on their lot after the 20s came out.
    7 replies | 163 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 09:01 PM
    We loved out Mojo, solid boat that did anything we asked of it. Can't go wrong with either, but the lines of the Mojo appeal to me.
    10 replies | 459 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 08:59 PM
    Just use the pop up pylon. That's why it is there.
    9 replies | 199 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 08:58 PM
    The new ZS232 is priced like a Mojo? Saw one loaded out going for around $115k at a dealer. I get nobody pays msrp, but can't see it getting down...
    38 replies | 747 view(s)
  • KnoxMojo's Avatar
    08-19-2019, 06:11 PM
    a couple companies make a power ball that inflates, it sits about halfway between the boat and tube. Keeps the rope from rubbing and keeps it from...
    9 replies | 199 view(s)
  • KnoxMojo's Avatar
    08-18-2019, 02:15 PM
    KnoxMojo replied to a thread New Helix in General Chat
    I was recently on a Helix with 5 adults and 4 early teens, it didn't feel cramped at all. There is so much storage and Moomba makes full use of that...
    10 replies | 313 view(s)
  • KnoxMojo's Avatar
    08-18-2019, 12:59 PM
    Right on, I've not seen any 2020 pricing out yet. At least they aren't thousands apart, so it really just comes down to what size is best for your...
    43 replies | 1376 view(s)
  • KnoxMojo's Avatar
    08-18-2019, 12:34 PM
    It is more like a $4-5k difference. I just looked it up on the Supra builder to verify, for the 19s anyway. Maybe after you negotiate or work a great...
    43 replies | 1376 view(s)
  • KnoxMojo's Avatar
    08-15-2019, 11:43 PM
    How many quarts of oil were you able to pull out?
    3 replies | 366 view(s)
  • KnoxMojo's Avatar
    08-13-2019, 10:08 PM
    KnoxMojo replied to a thread Fenders in General Chat
    I'd be interested in Babz at 18"..24" is huge and nobody wants to jump to the dock or another boat.
    36 replies | 1265 view(s)
  • KnoxMojo's Avatar
    08-12-2019, 09:54 PM
    KnoxMojo replied to a thread Fenders in General Chat
    Didn't even give a discount code for a few bucks off a $40 dollar hoppy ball. Lol
    36 replies | 1265 view(s)
  • KnoxMojo's Avatar
    08-12-2019, 09:34 PM
    You can fool your system by running an autowake profile at amplitude 0 pitch whatever you want and 0 roll. It'll do it for you on long cruises. Then...
    43 replies | 1376 view(s)
More Activity
About KnoxMojo

Basic Information

About KnoxMojo
Location:
Knoxville, TN

Signature


2018 Supra SA400 aka The Ron Burgandy
2011 Sea-Doo Wake 155
2015 Mojo Surf, sold...2013 Axis A22 Recon Edition, sold...2010 Axis A22, sold...2007 Maxum 180sr3, sold

Statistics


Total Posts
Total Posts
783
Posts Per Day
0.78
General Information
Last Activity
Yesterday 07:53 PM
Join Date
11-22-2016
Referrals
0