Stazi
Senior Member
Find latest postsMini Statistics
- Join Date
- 08-20-2011
- Last Activity
- Today 11:52 AM
- Avatar
More 4 Friends
Recent Visitors
- aotoupal,
- ArkHog,
- azfamily8,
- Chaney44ETX,
- GastonMojo,
- jnr4817,
- lsv11,
- Prospersigman,
- Samtuck,
- Snowslydder
- Tab Content
- Stazi's Activity
- About Me
- Friends
-
Older Activity
-
07-09-2020, 07:28 PMYeah my buddy has a huge 700+ lb bag on the floor and another in the nose. If I were you I’d seriously look at getting at LEAST 500lb of lead if not...5 replies | 83 view(s)
-
07-09-2020, 06:52 PMMy buddy has an SG and the stock ballast is not enough. You will need to add more ballast and/or upgrade your bags. Do you know what size bags you...5 replies | 83 view(s)
-
07-09-2020, 06:32 PMSo zero power at the pumps? How well can you trace the power wire from the switches? Do you have the breaker style fuses under the dash that have...4 replies | 86 view(s)
-
07-09-2020, 04:34 PMAku is the best surf style. Ahi is similar with a blunt nose. Sent from my iPhone using Tapatalk11 replies | 307 view(s)
-
07-09-2020, 04:33 PMThere might be a ballast breaker tripper in the engine bay. Sent from my iPhone using Tapatalk4 replies | 86 view(s)
-
07-08-2020, 08:11 PMProp would not do that. Sent from my iPad using Tapatalk13 replies | 300 view(s)
-
07-08-2020, 08:20 AMAre all the timers on a common ground? Is that ground good? If you bypass the timers you can just run the pumps in “manual” mode. Sent from my...6 replies | 96 view(s)
-
07-05-2020, 12:34 PMI recommend just buying new fitting and glueing those in as well. Use JB Weld Marine formula. Sent from my iPhone using Tapatalk4 replies | 99 view(s)
-
07-02-2020, 08:09 PMDamprid makes these plastic containers with a bag of deliquesent beads that I use for winter storage that soaks up humidity in the air. You can by...7 replies | 264 view(s)
-
06-29-2020, 12:56 PMWhat’s max speed on that, 25mph!? Sent from my iPad using Tapatalk4 replies | 157 view(s)
-
06-29-2020, 11:22 AMExactly as I described. Have some hold up on surf tab and see if they can resist it from moving when someone else deploys it. Sent from my...13 replies | 300 view(s)
-
06-29-2020, 09:26 AMActuator is bad if you can hold it with your hand when someone flips the switch and it doesn’t move. The internal clutch can give out. Sent from...13 replies | 300 view(s)
-
06-29-2020, 06:49 AMTurn off the boat completely with the battery switch for a minute. Then restart it and it should be back to normal. Sent from my iPhone using...13 replies | 300 view(s)
-
06-26-2020, 02:21 PMAdd the drain to the area next to the observer seat. No need for it to be up the front. Sent from my iPhone using Tapatalk1 replies | 84 view(s)
-
06-25-2020, 08:00 PMNo. It won’t show up without it being actually in the water. Sent from my iPhone using Tapatalk7 replies | 261 view(s)
-
06-25-2020, 05:28 PMIf it’s gone now it could have been anything, even a bag Sent from my iPhone using Tapatalk7 replies | 261 view(s)
-
06-25-2020, 10:30 AMStazi replied to a thread 07 LSV lack of acceleration and just doesn't sound right (louder under way) in Service & RepairThat’s a massive plug gap (0.060”) Sent from my iPhone using Tapatalk29 replies | 552 view(s)
-
06-25-2020, 10:30 AMCould have been a clump of weeds that eventually shredded. That will do the same thing. Sent from my iPhone using Tapatalk7 replies | 261 view(s)
-
06-24-2020, 09:53 AMSwim underneath and jam a shirt into the hole until you can get back to the ramp under slow tow - if you try to drive back under speed it might...36 replies | 1109 view(s)
-
06-23-2020, 02:28 PMThat’s just stupidity. Sent from my iPhone using Tapatalk36 replies | 1109 view(s)
-
06-23-2020, 08:19 AMStazi replied to a thread 07 LSV lack of acceleration and just doesn't sound right (louder under way) in Service & RepairCould be the fuel pump not delivering enough pressure. Sent from my iPhone using Tapatalk29 replies | 552 view(s)
-
06-22-2020, 01:27 PMI don’t like those long progressive waves. You can’t do much except surface tricks on a skim. The height even at the curl is so small. Sent...87 replies | 3090 view(s)
-
06-22-2020, 12:48 PMFind the connector to that pump and see if it’s corroded. Could be a bad ground within the pump motor itself. Sent from my iPhone using Tapatalk7 replies | 252 view(s)
-
06-22-2020, 12:34 PMBad ground on that drain pump Sent from my iPhone using Tapatalk7 replies | 252 view(s)
-
06-22-2020, 11:01 AMThe 6.5” Krypts aren’t bad at all. I had 4 of them on the tower of my old 2004 LS. You will need a minimum of 300w RMS per pair, if you wire...2 replies | 118 view(s)
-
06-19-2020, 05:34 PMAbsolutely Sent from my iPad using Tapatalk87 replies | 3090 view(s)
-
06-19-2020, 05:15 PMRagboys comment of using half wakeplate is erroneous. Sorry but it is. The wakeplate lift the ass end out of the water which is counterproductive...87 replies | 3090 view(s)
-
06-19-2020, 07:34 AMWatch my video on Autowake. https://youtu.be/2bVN071iYLM Sent from my iPhone using Tapatalk5 replies | 270 view(s)
-
06-18-2020, 10:20 PMCall Stewart Sure Step. They make a protector like that. I bought one off them for my Craz Sent from my iPhone using Tapatalk2 replies | 372 view(s)
-
06-18-2020, 10:29 AMTime it yourself and reset your timers. It won’t be exactly the same from boat to boat as voltage fluctuations affect how fast the pumps run. ...2 replies | 129 view(s)
About Stazi
Basic Information
About Stazi
- Location:
- Commerce Lake, MI
- Occupation:
- Engineer
Signature
2017 Moomba Craz
Statistics
Total Posts
- Total Posts
- 2,053
- Posts Per Day
- 0.63
General Information
- Last Activity
- Today 11:52 AM
- Join Date
- 08-20-2011
- Referrals
- 2
4 Friends
Showing Friends 1 to 4 of 4