View Full Version : tweaked my tower
04-15-2004, 12:33 AM
I tried to lower the tower on my Mobius by myself and somewhat dropped it, now it is very difficult to match up evenly with the holes in the mounting bracket. Has anyone found a way to lower the tower without help? I can raise tower alone. Any suggetions on "untweaking my tower?"
By the way, I have four speaker cans and a light bar which does add considerable weight when lowering the tower. Thanks Jim
04-15-2004, 02:55 AM
hi, first time i undid my rear bolts one side didn't match up with holes exactlyand was a bitch to get the bolt in. the dealer was too far so i took a larger diameter pipe so a towel could wrap around tower leg inside and bent leg so as to line up. took measures between cletes so i knew when i was there. i only had to bend it about 3/8 of an inch.
Its been fine for 3 yrs now. i have a 99 outbackls c ballast
04-15-2004, 09:22 AM
Not that this will help with the tweaked tower but if you are lowering your tower you might want to check out the rackjack.
Powered by vBulletin® Version 4.2.3 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.