View Full Version : Boatmate trailer
jmvotto
02-27-2009, 12:27 AM
Anyone know the inside dimension for the bow roller (between the metal uprights)for an 07 single axle boatmate. Is it 3.5" or 4" ? Mine is in storage so i can't look until may. I want to put a poly roller on it.
Thanks in advance
SEARK
02-27-2009, 12:36 AM
I changed mine last summer and I believe it's 3". I know it's not 4".
jmvotto
02-27-2009, 12:51 AM
Seark,
Thanks, 4" seams a little wide probably for bigger boats
montanamoomba
02-27-2009, 12:55 AM
Just measured mine. 2007 OBV, boatmate single axle trailer. 3.25" inside of plate to inside of plate.
jmvotto
02-27-2009, 08:05 AM
montana, thanks for the actual measurement. so 1/8" play on either side.for the 3" poly
moombadaze
02-27-2009, 08:18 AM
jm, have you thought about getting a boat buddie instead of the roller?
jmvotto
03-01-2009, 05:46 PM
Not really, the boat goes off and on the trailer about twice a year then sits in our lift after that. i just don't want to clean the black marks every year off the bow roller,therefore the poly roller.
Razzman
03-01-2009, 06:16 PM
It's the segmented 3" roller, replaceed mine last year.
04OUTBACK
03-01-2009, 10:26 PM
had to replace mine too.. the factory one ate up the gelcoat around the bow eye when it gave up and let the bolt inside rub against the bow! WOW>> THANKS.
canuckskier
03-02-2009, 07:15 PM
Hey Razzman.
Where did you get that roller from?
I really like it.
Cheers
Razzman
03-02-2009, 09:00 PM
Hey Razzman.
Where did you get that roller from?
I really like it.
Cheers
Right here, Stoltz Ultimate Bow Stop (http://www.overtons.com/modperl/product/details.cgi?i=74107&pdesc=Stoltz_Ultimate_Bow_Stop_fits_3_wide_bracket _4_1/4_dia_end_bell&str=stoltz&merchID=1008&r=view) from Overton's. I got the thing and the next time we launched the boat i bent over the bow and changed it out in about 90 seconds before backing off all the way. :p
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.