View Full Version : FAE Install

09-15-2008, 04:46 PM
I was the winner of the FAE system from the Moomba Jamboree. I have tried to document the install. Total time was probably around 4-5 hours. I did it over a few days.
The instructions are adequate for the install and only a few tools are needed. Larry at FAE, will respond to phone and emails quickly if you need help.

1. You will need to do a few measurements for the system in order for it to fit your boat.

2. System as it arrived in 2 boxes.

3. Flanges put into the exhaust ports.

09-15-2008, 04:49 PM
1. Install the FAE to check clearances.

2. Check Clearance with Wake plate up

3. Square tube, measure to fit

09-15-2008, 04:51 PM
Drill and tap treads for your bolts

Install square tube bracket

Installed and attached.

Of course, each boat will be different, but this is a general overview. There are a few ways to mount the square tube bracket to your swim platform, this is the way I chose.