View Full Version : board rack rubber failure

07-06-2008, 04:30 PM
anyone having trouble with the rubber failing out of the racks? My '06 LSV has all of the rubber is coming out of both racks. Any thoughts as to what type of glue to fix this?

07-06-2008, 10:13 PM
I've got that problem also. Haven't tried any fixes yet.

07-07-2008, 12:59 AM
Mine fell out. Scratched my new board. So I ripped them all out and reglue them back in. I used 30min epoxy. You can get it at any Home Depot or Hobby Store. Mine are still in to this day.

07-07-2008, 01:23 AM
Thanks Tazz, I'll try that.

07-07-2008, 09:46 AM
Make sure you have rubbing alcohal near by. Use a clean towel with the alcohal to remove any excess glue from around the rubber.
Glad to help.

07-07-2008, 04:49 PM
Being too lazy to completely remove the rubber inserts, clean, and reglue them on my previous boat, I simply added plastic zip ties. They work fine and aren't that noticeable. Zip ties can fit around each prong of the board rack and offer a long lasting fix.

07-07-2008, 08:19 PM
Thanks for the reply. How did you hold the rubber on the metal while the epoxy dried? Did you remove the rubber entirely and then start over? I only want to do this once!

07-07-2008, 10:32 PM
Mine fell out too ... just used the 5 minute epoxy from the local hardware store and has held up fine. 30 minute is likely a better route though may be a bit more rigid after cure.

07-08-2008, 12:13 AM
I used Duck tape to hold it down until it was complety cured.

08-14-2009, 05:27 PM
Sorry to dig-up and old thread, but I was curious if anyone has tried anything different to help protect their boards on these racks. I was thinking of buying some of that stuff they sell at Lowe's that people use to "rubber coat" their tools. Anybody do any experimenting???

(I have also thought about taking them to a rhino-lining place to have them sprayed, but am afraid that coating might be too course and scratch the boards anyways......)

08-15-2009, 10:25 AM
Mine fell out and I just ripped them out and reglued them. I don't remember what glue I used, but it was good stuff cause they are still there.