slacker
06-04-2008, 06:55 AM
Morning folks,
Hit a bit of a stumbling block here with the depth gauge on an '07 LSV.
Short of it is "it doesn't work". Why is the question...
The gauge is consistently showing "---" on the dash. After some investigation under the dash, it has what i believe to be power (red and black wires), however there is an extra wire that leaves the dash-mounted unit that splits into 3; these wires don't currently connect to anything and are just dangling. Can anyone w/ an 07 (or similar) factory depth gauge setup confirm what is / is not supposed to be connected to the back of the faceplate?
After flipping through the forum, thought maybe I had a transducer problem. Understand its supposed to look like a "puck" in the engine compartment. Anyone w/ an LSV able to provide any insight as to where in the engine compartment the transducer is supposed to be? Went on a bit of a hunt for it, but couldn't track it down.
Pictures, comments, otherwise always appreciated.
Thanks folks,
Slacker
Hit a bit of a stumbling block here with the depth gauge on an '07 LSV.
Short of it is "it doesn't work". Why is the question...
The gauge is consistently showing "---" on the dash. After some investigation under the dash, it has what i believe to be power (red and black wires), however there is an extra wire that leaves the dash-mounted unit that splits into 3; these wires don't currently connect to anything and are just dangling. Can anyone w/ an 07 (or similar) factory depth gauge setup confirm what is / is not supposed to be connected to the back of the faceplate?
After flipping through the forum, thought maybe I had a transducer problem. Understand its supposed to look like a "puck" in the engine compartment. Anyone w/ an LSV able to provide any insight as to where in the engine compartment the transducer is supposed to be? Went on a bit of a hunt for it, but couldn't track it down.
Pictures, comments, otherwise always appreciated.
Thanks folks,
Slacker