View Full Version : Light bar
03-16-2008, 08:37 PM
Hi All, I'm trying to get some specs on the new moomba LSV tower. I found a light bar on ebay for a pretty good deal but I can't figure out if it will fit. Secondly I can't find specs on the tower diameter to decide which clamps to get. Lastly, I would like to be able to control the front and back lights independently. Any sugguestions??
03-16-2008, 10:08 PM
Most manufactured light bars are wired so that all the lights come on the same. I emailed you about my light bar. You can rewire the bar. It should not be that hard. The two side pieces can be removed so access the wire. If you have a double accessory switch, this can be done. You will need two 4 wire bosh relay. One relay for each set of lights (front and rear)
Hope this helps.
03-16-2008, 10:42 PM
2 3/8" is the tower size
Powered by vBulletin® Version 4.2.3 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.