View Full Version : Toggle Switchs lose power when hit a bump
07-18-2007, 03:43 PM
I have a 07 XLV. Every time I hit a wake or if the water is slightly rough I lose all power to anything connected to a toggle switch, wake plate and horn. If I hit another bump they come back. I figured it was the breaker located next to the battery. However, during one of the times the power was out I checked the connections with a voltage meter and it was all good. Therefore the loss of power is occurring somewhere after the breaker. Question is where should I start checking for a lose connection. Any and all suggestions are appreciated since the delership is over an hour away.
07-18-2007, 06:21 PM
I'm not familiar with your particular boat, but I would check the circuit board to which the switches are wired. Could be a loose ground or (+) connection. Also check for any severely pinched or kinked wires within the circuit loop by wiggling them around and seeing if the power cuts out.
Just some thoughts... Good luck.
07-19-2007, 06:24 AM
Agreed, def sounds like a loose connection, and prolly a ground
Hope this helps
Powered by vBulletin® Version 4.2.3 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.