2007 LSV Ballast Switch Relocation

[acj3]

Hello all,
I will be installing the Wakemakers this weekend at my cottage. I found a post a little while ago of somebody that relocated the ballast switches to the same panel the key is on. I cannot for the life of me find this post. I would really like to move the switches as the factory location is terrible! If anybody knows of this post can you please let me know.

Thank you.

[996scott]

Is this what you're looking for? I relocated mine next to the throttle and it was so much better than down low.

https://forum.moomba.com/showthread.php?19546-Relocate-and-New-Ballast-Switches

[acj3]

Not the thread I found earlier. But this does have a ton of good info. Thank you. My plan was to move the switch plate over to the dash next to the key. I know I'll have to relocate the 12V plug.

I did see another thread where somebody moved the switch up close to the throttle and complained people kept hitting the switches with their elbows while driving.

[MJHSupra]

I did a switch plate move on my previous 2007 Supra years ago when I did the Wakemakers upgrade. It was originally located below the throttle lever and I moved it to the area above the throttle. Replaced the wires, switches, fuses, bus bar, etc. I also put some switches for the new LEDS - floor, cup holders, speaker rings.

I do not recall one about moving to the key-area, but it's probably out there.

[acj3]

I'm still searching for the thread.