cal1319
08-13-2023, 08:42 PM
Hi everyone!
My brother and I just turned in our 01 SAN 210 and got the Supra. Today was the first day we had it out and have a few issues that I’m hoping this group can help us sort out. One is the rear starboard ballast had a PDM fault and would not turn on. I reset ever breaker on the boat that I could find including the one in the engine bay tjay controls the ballast PDM board. I did this after we took the boat out of the water and the diagnostic screen does not show a fault anymore but can’t confirm the problem is fixed. The other ballast issue is that front tank/bag is leaking. When filling up I see water is getting into the hull. Anyway to track the issue here?
We also have misfire in cylinder 4 message but can’t tell if that was an old code because we did not feel/hear any misfire even with two race car engine builders one the boat with us.
The tower speakers decided to stop working even though they were on yesterday and you can hear a slight hmmm. Tried to mute and unmute them with no luck.
Lastly, the prop nut started to back itself off while we were out for a few hours. I have never seen this happen before. Could it just be whoever installed it did a crappy job? We didn’t feel any vibration that would indicate a bent prop or something that might cause the nut to lossen up.
Thank you all for your time and we are very excited to get this boat dialed in. Also engine has 253 hours on it.
My brother and I just turned in our 01 SAN 210 and got the Supra. Today was the first day we had it out and have a few issues that I’m hoping this group can help us sort out. One is the rear starboard ballast had a PDM fault and would not turn on. I reset ever breaker on the boat that I could find including the one in the engine bay tjay controls the ballast PDM board. I did this after we took the boat out of the water and the diagnostic screen does not show a fault anymore but can’t confirm the problem is fixed. The other ballast issue is that front tank/bag is leaking. When filling up I see water is getting into the hull. Anyway to track the issue here?
We also have misfire in cylinder 4 message but can’t tell if that was an old code because we did not feel/hear any misfire even with two race car engine builders one the boat with us.
The tower speakers decided to stop working even though they were on yesterday and you can hear a slight hmmm. Tried to mute and unmute them with no luck.
Lastly, the prop nut started to back itself off while we were out for a few hours. I have never seen this happen before. Could it just be whoever installed it did a crappy job? We didn’t feel any vibration that would indicate a bent prop or something that might cause the nut to lossen up.
Thank you all for your time and we are very excited to get this boat dialed in. Also engine has 253 hours on it.