vdubnick
05-03-2022, 11:36 AM
FYI, just got a 2022 mojo, delivered october 21.... over winter i have been adding some more accent lighting and noticed a couple loose nuts on the tower mount.
Something worth checking if you have gotten a new boat. one of the nuts had about a 1/16" gap, washer was visibly loose. Super easy to tighten them up, and i am glad i caught it before the rubber gasket shifted.
Another few items:
I found a few dangling connectors/harnesses in the engine bay, zip tied them up so they dont become failure points years down the road.
The trim panel above the throttle was not fully seated. I noticed when i was running wires. The issue was the bundle of cables/wires directly behind the wireless charge pocket. The large bundle was resting on top of the pocket and pushing the panel out. I was able to rearrange things a bit and got rid of the interference.
one of the cup holders in the middle bow area was sitting crooked. It was getting pushed on by a ballast hose... repositioned it and all is well.
The 700 dollar storage bins had square edges and caught the upholstery when you opened the lockers. making a noticeable click. I pulled them out and used a 3/18" round over bit to nock off the sharp edge. works smoothly now.
Another item i have yet to address is the center cockpit floor/fuel tank cover. The front side sits a little high, about 1/8-1/4" potential tripping hazard, but it may need the FG trimmed down.
I suppose I could try and hold the dealer to fix some of these, but in my experience, things get half assed on warranty repair.
Something worth checking if you have gotten a new boat. one of the nuts had about a 1/16" gap, washer was visibly loose. Super easy to tighten them up, and i am glad i caught it before the rubber gasket shifted.
Another few items:
I found a few dangling connectors/harnesses in the engine bay, zip tied them up so they dont become failure points years down the road.
The trim panel above the throttle was not fully seated. I noticed when i was running wires. The issue was the bundle of cables/wires directly behind the wireless charge pocket. The large bundle was resting on top of the pocket and pushing the panel out. I was able to rearrange things a bit and got rid of the interference.
one of the cup holders in the middle bow area was sitting crooked. It was getting pushed on by a ballast hose... repositioned it and all is well.
The 700 dollar storage bins had square edges and caught the upholstery when you opened the lockers. making a noticeable click. I pulled them out and used a 3/18" round over bit to nock off the sharp edge. works smoothly now.
Another item i have yet to address is the center cockpit floor/fuel tank cover. The front side sits a little high, about 1/8-1/4" potential tripping hazard, but it may need the FG trimmed down.
I suppose I could try and hold the dealer to fix some of these, but in my experience, things get half assed on warranty repair.