Ladder Install on 2020 Moomba Makai

[brandykn00]

I would like to install an under platform ladder on my boat and wanted to know if I can screw it on without drilling all the way through the platform? Or do I need to drill through it and install with bolts?

[haknslash]

You can do it without screwing all the way through as others have done. I think they all share the same swim platform.

[Holdmybeer]

Also use some sort of adhesive to help support the screws. Like most things on the hull 5200 does the work and the screws are support.

I would not use 5200 though, unless you plan to never take it off. Use 4200 and stainless screws.

[SONIC]

I added one to my SA, the platform is thick so the screws don't go all the way through. I assume the Makai platform is similar if not the same.
And I agree either 4200 or 5200 3m adhesive.

[HFarr]

I would like to install an under platform ladder on my boat and wanted to know if I can screw it on without drilling all the way through the platform? Or do I need to drill through it and install with bolts?If you don't mind, post a few pics when and if you install the ladder. I may put one on mine as well. If we float without the ballast full, it's a bit if a pain to get back up there.

Sent from my moto z4 using Tapatalk

[Holdmybeer]

Guys,

z28ke already did this to his Max.

https://forum.moomba.com/showthread.php?31541-Murder-Max-Mods/page19
Post 187 and the following

1" screws work and do not go all the way through. Pre-drill the fiberglass first and use some sealant.

Do a small write-up if you have time. Lets see the work.

[sandm]

https://forum.moomba.com/showthread.php?33256-Ladder-for-Moomba-Max&highlight=ladder

try this thread. more pics and details.
we bought one and were all set to install but sold the boat. I think it would have been one of the best non-ballast mods.