Holdmybeer
04-26-2021, 02:33 PM
Been searching all weekend for something that I don't know if it exist.
I built a wider cross-member for 1 of my board racks to hold skis. It turned out great and it now 29" long to support outside of the bindings.
I already ordered new tines for the swivel rack that I pillaged so I can hold a kneeboard.
However, once I mounted my new wider rack to the upper mount of my S-bend tower I noticed it was not level. It is about a 15 deg difference front down. I used the same mounting pattern from my other rack. I checked the Roswell site thinking I screwed up and they have the same thing. What am I missing? Do they make something to allow the rack to rotate? I don't want the skis to fall out not being level in the rack. I could also get a large surf board up there when not skiing but then again they will be sloped forward 15 deg.
Any ideas? Anyone seen this?
I can post pictures after work, I know it would help.
I built a wider cross-member for 1 of my board racks to hold skis. It turned out great and it now 29" long to support outside of the bindings.
I already ordered new tines for the swivel rack that I pillaged so I can hold a kneeboard.
However, once I mounted my new wider rack to the upper mount of my S-bend tower I noticed it was not level. It is about a 15 deg difference front down. I used the same mounting pattern from my other rack. I checked the Roswell site thinking I screwed up and they have the same thing. What am I missing? Do they make something to allow the rack to rotate? I don't want the skis to fall out not being level in the rack. I could also get a large surf board up there when not skiing but then again they will be sloped forward 15 deg.
Any ideas? Anyone seen this?
I can post pictures after work, I know it would help.