2017 Moomba MOJO surf Edition winterizing

[Kearnzee]

Looks like there are 5 drain points on my 2017 MOJO with the 440 Raptor.
I found one on the heat exchanger, another on the bottom of the v-drive,
And then I disconnected the cross over hose. Where are the other two?

[larry_arizona]

Looks like there are 5 drain points on my 2017 MOJO with the 440 Raptor.
I found one on the heat exchanger, another on the bottom of the v-drive,
And then I disconnected the cross over hose. Where are the other two?

The impeller housing is one, however, unless you are changing the impeller it’s unnecessary.

Then there is a hose from the transmission with a brass fitting and a blue plug in it on the starboard side, it’s tricky to find it.


Sent from my iPhone using Tapatalk

[Kearnzee]

Where is the impeller housing?

[larry_arizona]

Where is the impeller housing?

Center of the crankshaft pulley.
https://uploads.tapatalk-cdn.com/20201018/fcf66d2767843e656d1a39d43a076b67.jpg



Sent from my iPhone using Tapatalk

[Kearnzee]

Perfect thanks.
Can't find any brass fitting with the blue plug on the transmission line starboard side.?

[larry_arizona]

Perfect thanks.
Can't find any brass fitting with the blue plug on the transmission line starboard side.?

It’s tricky to find.


Sent from my iPhone using Tapatalk

[BigOrange]

Wouldn't the remaining plug be the plastic blue "wing-nut" type plug on the port back of the heat exchanger cylinder? Looking down from above oriented toward front of the boat, look for it protruding at about 7 to 8 o'clock off the HX.

[rdlangston13]

Wouldn't the remaining plug be the plastic blue "wing-nut" type plug on the port back of the heat exchanger cylinder? Looking down from above oriented toward front of the boat, look for it protruding at about 7 to 8 o'clock off the HX.

This, should be on the front of the engine (back of the boat) starboard side