View Full Version : Removable Engine Panel Reinforcement
jcarter20
03-09-2020, 12:42 PM
I know some of you have had to add additional reinforcement to the removable engine sidewall panels. Do any of you have pictures of what you have done? I am not talking about the aluminum track at the bottom, I already have that. I am still experiencing some bowing of the panel itself and was going to add a stiffener or two. Just curious what others are doing.
Sent from my iPhone using Tapatalk
jcarter20
03-09-2020, 12:44 PM
This is the panel that I have. As you can see it already had some built in channels for reinforcement, but they are not enough.
https://uploads.tapatalk-cdn.com/20200309/36af1662f8f4f26f7d58b11aa72aa70e.jpg
Sent from my iPhone using Tapatalk
RC_Hinojosa
03-09-2020, 01:25 PM
So my 2017 had the metal reinforcement channels on the panels themselves just like yours, I went ahead and added the Wakemakers panel saver kit to them as well.
On the engine side of the panels I also added Aluminum 'L' stock taller than the panel channel to keep panel from jumping track.
These mods keep my Enzos in check [emoji57]https://uploads.tapatalk-cdn.com/20200309/a2f4e30601438f8ffb3051661640374f.jpghttps://uploads.tapatalk-cdn.com/20200309/f5da6d023485dceda159479e58880fa9.jpg
Sent from my Note9 using Tapatalk
jcarter20
03-09-2020, 02:32 PM
Nice! Thanks. I will check out the panel saver kit.
Sent from my iPhone using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.