View Full Version : V2 or oz/ozHD
newbie1993
06-13-2019, 10:06 PM
looking for a new tower for my 2009 mobius. have a crappy aerial tower now. not happy with it . its rickity and flexes a lot. looking for a more modern looking, foward leaning tower like V2/oz
any one know where i can get one of these towers? or any one have a recomendation for a solid aftermarket tower?
I had mine made for an older outback. Made a drawing of what I wanted and $2000 later done. However mine is the normal style but stronger than most Alu toweres
Shoebox
06-14-2019, 03:26 PM
looking for a new tower for my 2009 mobius. have a crappy aerial tower now. not happy with it . its rickity and flexes a lot. looking for a more modern looking, foward leaning tower like V2/oz
any one know where i can get one of these towers? or any one have a recomendation for a solid aftermarket tower?If you're going to replace the tower, don't get an Oz. That's my one gripe with my boat. It looks good, but it's too short, and the forward sweep puts the tow point too far forward. Get the Aviator from Roswell.
newbie1993
06-14-2019, 09:30 PM
not sold on the way the roswel tower looks/mounts
newbie1993
06-16-2019, 06:50 AM
Bump to the top
newbie1993
06-09-2021, 12:43 PM
Still looking
SONIC
06-09-2021, 12:54 PM
I put a monster MTK on my last boat (Tige 23V) and liked it.
Very solid.
29794
HFarr
06-09-2021, 10:54 PM
I put a monster MTK on my last boat (Tige 23V) and liked it.
Very solid.
29794I had that same tower on a Crownline I owned. Nice solid beefy tower and looked good. Only thing I did not like was the pain it was to unscrew the knobs through the spherical rod end bearings in order to fold the tower. Getting them lined back up on mine was a bit aggravating. Always had to apply pressure to the tower to get them to line up just right.
Sent from my moto z4 using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.