utexasrick
06-05-2019, 11:17 PM
Doing some maintenance before I take the boat out after being in storage
I’ve always had a problem with starting the boat after being cold even when I try to start it up after being anchored.
I will start right up and i hold the rpms around 1k out of gear but sometimes as soon as I try to put it in gear and go it dies.
Then it takes a few times of doing the same thing and it gets going
If I do it quick enough I can get the boat going without dying but usually it’s in a no wake zone so I can’t gun it.
I’ve read that adjusting the idle air bleed screws can potentially help with idle issues.
Can someone point out if these are the correct screws to adjust? One on each side of the carb. Didn’t see any brass caps so I’m assuming someone previously had taken them out already
I’ve got a 2006 mobius lsv
https://uploads.tapatalk-cdn.com/20190606/d0565e792d9c6da422874ba335f299ee.jpg
Sent from my iPhone using Tapatalk
I’ve always had a problem with starting the boat after being cold even when I try to start it up after being anchored.
I will start right up and i hold the rpms around 1k out of gear but sometimes as soon as I try to put it in gear and go it dies.
Then it takes a few times of doing the same thing and it gets going
If I do it quick enough I can get the boat going without dying but usually it’s in a no wake zone so I can’t gun it.
I’ve read that adjusting the idle air bleed screws can potentially help with idle issues.
Can someone point out if these are the correct screws to adjust? One on each side of the carb. Didn’t see any brass caps so I’m assuming someone previously had taken them out already
I’ve got a 2006 mobius lsv
https://uploads.tapatalk-cdn.com/20190606/d0565e792d9c6da422874ba335f299ee.jpg
Sent from my iPhone using Tapatalk