Missing oil pressure gauge. Possible it wasn’t an option?

[Fisherman302]

Hey guys the boat is a 2005 moomba mobius LSV. I bought the boat not too long ago and have been fixing some issues along the way thanks to your help. There is a blank gauge on the dash with no needle or numbers I’m assuming where the oil pressure gauge should be. I didn’t question it when I bought it since it was a blank gauge. Is this normal or did someone replace the gauge with a blank one? Was it an option for that year? I feel like oil pressure should be standard. Anyways here are a few pictures of the gauge and behind the console looks like there is a connector hanging there for the oil pressure I could be wrong? Check the pics and let me know what you think. I tried looking around in the motor for an like pressure sender but couldn’t locate anything that looked like it. Where can this be found?

[VA LSV]

Oil pressure gauge should be standard. What gauges do you have on the right near the throttle? That's where the optional wakeplate and depth gauges would be and should be the only place where blank gauges whould have been installed.

[trayson]

My oil sender is basically right by the remote oil filter housing. just to the stern of the oil filter.

I have an oil pressure gauge that I pulled off my boat when I swapped out to a digital one. I think it was my sender that was bad, but I replaced both. I don't know if my guage is good or not, but if you have a harness maybe it'd work? I could take a look at the back of it and see if that is what would mate up with yours. It's just 3 or 4 wires IIRC.

[Fisherman302]

My oil sender is basically right by the remote oil filter housing. just to the stern of the oil filter.

I have an oil pressure gauge that I pulled off my boat when I swapped out to a digital one. I think it was my sender that was bad, but I replaced both. I don't know if my guage is good or not, but if you have a harness maybe it'd work? I could take a look at the back of it and see if that is what would mate up with yours. It's just 3 or 4 wires IIRC.

Much appreciated. So behind where the blank gauge is there is a 4 wire connector underneath the dash. I was also able to locate the sender and the wiring that goes to it. The wire on the tip of the sender was unplugged. I wonder why. Anyway here are some pictures of what I found. What’s the other wires connector right next to the sender? Is that an oil sensor?

27771
27770