View Full Version : Surf tabs
Amc0825
08-11-2018, 11:39 AM
When surf switch is in the neutral position, the starboard plate hangs down approx. 1/2 inch lower. Is this normal?
Sent from my SM-G955U using Tapatalk
Stazi
08-11-2018, 01:39 PM
When surf switch is in the neutral position, the starboard plate hangs down approx. 1/2 inch lower. Is this normal?
Sent from my SM-G955U using Tapatalk
Probably just some slop in the linkage. As long as the actuators fully retract when you are in the middle position, it won’t affect anything.
Sent from my iPad using Tapatalk
Amc0825
08-11-2018, 01:57 PM
Ok I think they are. I will have my wife switch them while I watch to see if they are moving correctly.
Sent from my SM-G955U using Tapatalk
Jeepers
08-11-2018, 05:19 PM
Check to see if the transom actuator bracket isn’t bent. I had someone decide to use my port side trim tab as a foot step climbing out of the water and bent/snapped the actuator bracket right off.
Sent from my iPhone using Tapatalk Pro
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.