View Full Version : Need help . No power
JHCMondo
05-13-2018, 01:15 PM
I hooked up the batteries as per the manual and flipped the switch.
The computer turns on, the tabs move up and down, the guages do the full test sweep but no power to blower, radio and ballast pumps.
Did I miss something. I checked the fuses and they seem ok.
The fact the computer turns on I'm assuming means I connected the battery right.
Any help appreciated
Thanks!
Stazi
05-13-2018, 01:20 PM
I hooked up the batteries as per the manual and flipped the switch.
The computer turns on, the tabs move up and down, the guages do the full test sweep but no power to blower, radio and ballast pumps.
Did I miss something. I checked the fuses and they seem ok.
The fact the computer turns on I'm assuming means I connected the battery right.
Any help appreciated
Thanks!
Check all the breakers. One near battery and one in engine bay.
Sent from my iPhone using Tapatalk
JHCMondo
05-13-2018, 01:22 PM
Missed a ground and connected it and everything works!
Stazi
05-13-2018, 01:23 PM
Missed a ground and connected it and everything works!
That was going to be my next question. Did you forget to connect a cable to the battery.
Sent from my iPhone using Tapatalk
JHCMondo
05-13-2018, 01:25 PM
Yeah..... I'm mechanically illiterate :o but I'm learning.
Next step is to replace the raw water impeller. Hopefully that goes smoothy
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.