Need help . No power

[JHCMondo]

I hooked up the batteries as per the manual and flipped the switch.

The computer turns on, the tabs move up and down, the guages do the full test sweep but no power to blower, radio and ballast pumps.

Did I miss something. I checked the fuses and they seem ok.

The fact the computer turns on I'm assuming means I connected the battery right.

Any help appreciated

Thanks!

[Stazi]

I hooked up the batteries as per the manual and flipped the switch.

The computer turns on, the tabs move up and down, the guages do the full test sweep but no power to blower, radio and ballast pumps.

Did I miss something. I checked the fuses and they seem ok.

The fact the computer turns on I'm assuming means I connected the battery right.

Any help appreciated

Thanks!

Check all the breakers. One near battery and one in engine bay.


Sent from my iPhone using Tapatalk

[JHCMondo]

Missed a ground and connected it and everything works!

[Stazi]

Missed a ground and connected it and everything works!

That was going to be my next question. Did you forget to connect a cable to the battery.


Sent from my iPhone using Tapatalk

[JHCMondo]

Yeah..... I'm mechanically illiterate :o but I'm learning.

Next step is to replace the raw water impeller. Hopefully that goes smoothy