Spn 110?

[BrettLee3232]

Threw this code at the launch ramp. What is it?https://uploads.tapatalk-cdn.com/20170927/0f7dbbe93fd1c4d2b277bdccbc201d14.jpg


Sent from my iPhone using Tapatalk

[mattsask]

Threw this code at the launch ramp. What is it?https://uploads.tapatalk-cdn.com/20170927/0f7dbbe93fd1c4d2b277bdccbc201d14.jpg


Sent from my iPhone using TapatalkIt just means you sucked up some debris. You may have to get the sensor cleaned. I've been getting that fault hourly since May. Dealer said it's nothing to worry about, and it's a three hour drive, so I've just been acknowledging mine.

Sent from my SM-G930W8 using Tapatalk

[Pound]

This is an easy fix. It's the sensor that determines if enough water is flowing for the cooling system or some such. It's easily accessible and you can unscrew it, clean it, and re-install it in seconds. Just make sure that when you put it back in, it's oriented properly for the paddlewheel to read the flow properly. I did this on mine and haven't had the code since. when i took it out, i could feel some sandy grit in the paddlewheel. spun it by hand and ran some bottled water over it and it freed up nicely. stuck it back in and no more problem.
There's a thread around here somewhere w/pics of where to find this sensor. I'll post a link to it if i find it.

[Pound]

Found it.

https://forum.moomba.com/showthread.php?29605-Fault-Warning-SPN-110-FMI-1/page2&highlight=fault