Mart
07-06-2017, 01:56 PM
Hi,
I seem to have a problem with the wakeplate on my 2011 LSV.
Although the wakeplate indicator I showing the wakeplate going up or down as I use the ''blinker type'' controller on the steering wheel, I don't feel the boat attitude to be as impacted as before so I think the actuator (LENCO) is not moving much anymore.
My trailer is in storage therefore before getting the boat out of the water, I want to troubleshoot to a maximum on the water.
The wakeplate indicator only works when the boat engine is running therefore I assume that the same applies to the actuator.
Not a big fan of sticking my hand on the wakeplate while engine is running in neutral.
Before I get my scuba mask to look at it from a safe distance, do you have any pointers to check ?
I would think that the wakeplate indicator should not show movemment if the wakeplate is not moving but the position indication is probably only based on the blinker controller demand and not on actual actuator position.
thanks a lot
Martin
I seem to have a problem with the wakeplate on my 2011 LSV.
Although the wakeplate indicator I showing the wakeplate going up or down as I use the ''blinker type'' controller on the steering wheel, I don't feel the boat attitude to be as impacted as before so I think the actuator (LENCO) is not moving much anymore.
My trailer is in storage therefore before getting the boat out of the water, I want to troubleshoot to a maximum on the water.
The wakeplate indicator only works when the boat engine is running therefore I assume that the same applies to the actuator.
Not a big fan of sticking my hand on the wakeplate while engine is running in neutral.
Before I get my scuba mask to look at it from a safe distance, do you have any pointers to check ?
I would think that the wakeplate indicator should not show movemment if the wakeplate is not moving but the position indication is probably only based on the blinker controller demand and not on actual actuator position.
thanks a lot
Martin