Ballast pump O-Rings?

[BrettLee3232]

Well I replaced all my impellers, only one was bad but what the hell. Well the o-ring was gone on 2 of them. Didn't have any so just went without them. Well it leaked like a sieve.

Anyone know where to get them for the 15 Mondo? I assume wake makers but I'm to lazy to look 🤷🏼*♂️


Sent from my iPhone using Tapatalk

[BrettLee3232]

I case anyone is confused it's these black rings.....https://uploads.tapatalk-cdn.com/20170618/709c9b7ae6e0a074fd0e383500e9ca38.jpg


Sent from my iPhone using Tapatalk

[BrettLee3232]

So I found this..... but I don't need screws or an impeller. Just the o ring.

https://www.wakemakers.com/jabsco-ballast-puppy-pump-service-kit.html

Guess I'll call wakemakers and see if they can just sell the o ring or contact jabsco.


Sent from my iPhone using Tapatalk

[z28ke]

You can probably find one that will work at the hardware store in the plastic cases on the hardware isle.

[moombadaze]

^^^^Tried this myself when I had mine leaking, no luck at Ace hardware, Lowe's or Home depot, even tried a pool supply store, some where close, bought a couple but they didn't seal worth a crap

[BrettLee3232]

^^^^Tried this myself when I had mine leaking, no luck at Ace hardware, Lowe's or Home depot, even tried a pool supply store, some where close, bought a couple but they didn't seal worth a crap

So what did you end up doing?


Sent from my iPhone using Tapatalk

[BrettLee3232]

I just got an email back from Jabsco. They are asking for model # & serial #. I'm hoping one of you fine lads with a 15 can verify the model number of the pumps for me please? My boats 3 hours away [emoji1304]


Sent from my iPhone using Tapatalk

[moombadaze]

ordered from wakemakers the impellars with orings. sucked, but no more leaks and then I had xtra impellars for the next change, I was just a lot more care full with the orings