PDA

View Full Version : trailer DIY swing away



jmvotto
11-30-2016, 09:18 AM
Anyone use these, I was looking to do one on my pontoon trailer if needed for new garage .

http://www.etrailer.com/Folding-Tongue/Fulton/FHDPB330301.html?feed=npn&gclid=Cj0KEQiA6_TBBRDInaPjhcelt5oBEiQApPeTF7i-Lsr8JWGLv2SYBzlCrwJpEkrboVqqWXVBVqp8FVoaAt5E8P8HAQ

moombadaze
11-30-2016, 12:53 PM
Joe, I did one on my 2004? 18' Key west bay boat a few years back. Super simple to do, they gave a guide to make the cut with, then its just drilling holes and bolting in back together. Must of done it ok as I saw the boat and trailer a few months back and it was still in use, and that's with the trailer being dunked in salt water

jmvotto
11-30-2016, 02:45 PM
thanks, this trailer will get used twice a year once I get it.

kaneboats
12-01-2016, 12:09 PM
Can't be too hard. Long as there are no brakes to deal with. Good luck!