2014 Mojo side seat ballast size

[Flee27]

Does anyone know the dimensions inside the side seats. I would like to order some bags for these compartments and am trying to get them before the weekend. My plan would be to piggyback them off the 1100s in the rear corners, if anyone has any advice/warnings they are welcome.



Thanks in advance.

Foster

[BrettLee3232]

Does anyone know the dimensions inside the side seats. I would like to order some bags for these compartments and am trying to get them before the weekend. My plan would be to piggyback them off the 1100s in the rear corners, if anyone has any advice/warnings they are welcome.



Thanks in advance.

Foster

I think 325lb fits perfect if I remember from previous Install's. I believe wolfman had that in his mojo.

I have the 225lb in my mondo. I T'd off from the fill line & overflowed into my 900lb. Works great.


Sent from my iPhone using Tapatalk

[Ironcross25]

not sure the difference from 12 to 14 but 325 fits well on the port but my cooler is on the other side. They do make 1500's that extend into the compartment that would eliminate the piggybacking. Im going to upgrade my 1100 to the 1500 and move the 1100 to opposite side this winter.

[wolfeman131]

I think 325lb fits perfect if I remember from previous Install's. I believe wolfman had that in his mojo.



Close!

I don't think wakemakers had sumo bags when I had the mojo, so I used this Flyhigh tube sac @ 370 lbs:

https://www.wakemakers.com/fly-high-tube-sac.html

I plumbed it off the port 1,100. Call me if you have ?'s

[jeamk03]

It'll make a huge difference. Especially if you don't always have a large crew.

If your 1100s have fittings on both sides, I think you can just connect them. Mine didn't, so I t'd off fill/drain line. Works perf and fills roughly same amount of time as center/IBS.

I just shoved my stock 650s under seats. Works well enough. Mine will overflow drain before popping seats up because top opening is much smaller than space beneath, which is nice.

Sent from my SM-G900V using Tapatalk

[wolfeman131]

If your 1100s have fittings on both sides, I think you can just connect them.


I think I tried this and it didn't work well for draining the tube sac, so I T'd off the fill line.

[ghebert1111]

Are you after a surf wave and have you tried a suckgate yet? I have 900 lb bags in my lockers and I'm still testing things but I think I'm getting my best surf wave with about 600 lbs in each locker and the 650 IBS filled. I'm not sure why but I think with the suckgate on the flat part of the mojo, when you fill the lockers to much the top of the suckgate is so far under water, that it's effects are negated.

This route might save you a bit of money.