prop

[newbie1993]

i just got back from the lake and had my 3 400 stock bags filled. also had an additional 540 lb full in the passenger side locker and another 150 ish in the floor. we gave it some gas and and couldn't get above 10 mph even revving the engine off perfect pass still wouldn't go. in thinking it could be the prop not having enough butt to push the boat and spinning

also i have an inmarr assault 325 i recently changed the plugs and wires due to it smoking a little but since i swapped it out it got a little worse and smells like its running a rich. what could this be?

[mmandley]

Your honestly not running a lot of weight, which prop are you currently running?

My LSV same engine would plane just fine with 3k in it evenly weighted, took some time but it did it.

If your smelling a lot of fuel like it's rich, your O2 sensors might be failing, hard to say with out a computer to read it.

[Mwcraz]

X2 on the o2 sensor. These will cause an engine to run rich. They are easy to change and not too expensive. Depending on age and hours it would be good to replace them. If you are running rich it will reduce engine performance and increase fuel consumption.

[DFTR Josh]

Check the rim on your prop and see what it says (Example 13x16) so we know where you stand. Like posted above you're not running a lot of weight but a lot of other factors can also get in the way with people, gear, gas, cooler ;), etc.

[newbie1993]

I'm running a 13.5x16 4 blade and does anon know where the o2 sender is on an 09 325 assault. or to one jup that any one know where i can get the motor manual for it?

[icemanftr]

I'm running a 13.5x16 4 blade and does anon know where the o2 sender is on an 09 325 assault. or to one jup that any one know where i can get the motor manual for it?

Seems like more of a speed prop. Mine is an acme 1617 which is like 14/14.5 or something. Pulls my boat out of water like a raped ape with 3300# ballast and up to 8 people.


Sent from my iPhone using Tapatalk

[DFTR Josh]

out of water like a raped ape with 3300#
I guess I'm picking on ape's also since I'm running the stock OJ945 15"x13p. Forgot to mention elevation will be a big player also. 13.6x16 isn't a prop to really push weight...

[newbie1993]

Ok that's what I was hoping. Praying there wasn't something majorly wrong with it. What prop would yall recomend? Plan on plumbing 1100 in each locker and 1000 additional up front over the winter.


Sent from my iPhone using Tapatalk

[Woody929]

The 1617! I have one that I took off of my LSV when I sold it that I need to sell

[newbie1993]

Pm me with a price shipped to Monroe ga


Sent from my iPhone using Tapatalk

[DFTR Josh]

V What prop would yall recomend
At 900' elevation you might have decent success with the 1617 posted above. You can go extreme with the 2079 and not have a worry about weight at all. It will kill your top speed quite a bit though.

[newbie1993]

All my lakes are below 400 elevation


Sent from my iPhone using Tapatalk

[newbie1993]

Here is another thought. I have a perfect pass system on my 09. If I swap the prop will it still be calibrated right? Or do I have to adjust something. I do know it has the paddle wheel on the underside


Sent from my iPhone using Tapatalk

[Flee27]

What lakes do you like to visit? I also live in Monroe.

Foster

[newbie1993]

wives family have a house on sinclair, i own a remodeling company and when we get off early me and a buddy head to jackson and when saturday morning allows i go to macon and ski tobo with me dad
what part you live in i live off troy smith

[Flee27]

wives family have a house on sinclair, i own a remodeling company and when we get off early me and a buddy head to jackson and when saturday morning allows i go to macon and ski tobo with me dad
what part you live in i live off troy smith

I live off Hwy 138/Nunnally Farm on the other side of 78. Lake Jackson house in down on the dam end of the lake.

[DFTR Josh]

Here is another thought. I have a perfect pass system on my 09. If I swap the prop will it still be calibrated right? Or do I have to adjust something. I do know it has the paddle wheel on the underside
The paddle wheel will read the speed so no need to adjust anything with a new prop most times.

[sandm]

I'm running a 13.5x16 4 blade

same prop that came on my 20ssv. best thing I ever did was swap out for an acme 1235.
I was going to keep that one for spare but ended up selling it after a year realizing if it didn't work good now, why keep.

[newbie1993]

I live off Hwy 138/Nunnally Farm on the other side of 78. Lake Jackson house in down on the dam end of the lake.
thats whats up
we are wanting to get a lake house some wear around our end of jackson that needs some fixing up in the next year or 2