PDA

View Full Version : Exile Xi800.4 4 Channel Amp...



ian ashton
02-29-2016, 10:13 PM
https://www.dropbox.com/s/sxoyf2pnb68ruvo/photo%20jul%2004%2C%2012%2022%2013%20pm.jpg?dl=1

$200 shipped?

I've run this amp on 6 SX65Ms for the last few years, and it's been a great amp - I'm upgrading to the XM15.4 because my OCD is going nuts with non-matching amps on that amp rack.

Specs:

Length: 16in. (457mm)
Width: 10in. (254mm)
Height: 2.5in. (64mm)

Into 4 ohm Stereo: 125W x 4
Into 2 ohm Stereo: 200W x 4
Into 4 ohm Bridged: 400W x 2

Onboard Fuse Size: 30A x 2

Power / Ground Wire Size: 4 Gauge

Frequency Response± 1dB from 20Hz - 20kHz
Signal to Noise Ratio>110dB
HP and LP Xovers

18dB per octave
LP Xover Range40Hz - 400Hz
HP Xover Range20Hz - 400Hz
Input Sensitivity200mV - 8V
Lowest Recommended Load4 ohm Bridged or 2 ohm Stereo
Typica Efficiency50%

ian ashton
02-29-2016, 10:14 PM
And yes, that is ice melting on the heat sink with the input signal meters pegged. As I said - it's dialed in, sounds amazing, and never let me down :)

mikenehrkorn
03-01-2016, 08:22 AM
PM sent......

evoimport6
03-03-2016, 11:44 AM
Did this ell? If not then I want, will pay pall the money immediately.

mmandley
03-03-2016, 01:10 PM
Did this ell? If not then I want, will pay pall the money immediately.

I gave your name to another guy on the forum I think will be selling an 800.4 as well, he should be messaging you today at some point.

This is of course if Ian sold his amp.

evoimport6
03-03-2016, 06:53 PM
Thank you sir.

ian ashton
03-05-2016, 08:39 AM
Sorry guys, I didn't have notifications turned on for this forum, responding to PMs now!

ian ashton
03-06-2016, 09:20 AM
Sold, thanks guys!