PDA

View Full Version : Bunk Spacing and Height for 2013 Mobius LSV



GregF
12-18-2015, 04:59 PM
Just bought a 2013 Mobius LSV (my first boat!) and will be storing it on a lift. Was wondering if anyone could provide me with the bunk spacings both front and back. I don't have a trailer available to measure. Also, what is the bunk height both front and back for the bunks to allow clearance for the fins and prop underneath?

Any help here would be greatly appreciated. I'm new to this!

Greg

jstenger
12-18-2015, 05:43 PM
My lift is on shore. I will try to measure tomorrow. I do know that I kept the bunks straight front to back. It worked perfect all summer.

GregF
12-26-2015, 08:43 PM
My lift is on shore. I will try to measure tomorrow. I do know that I kept the bunks straight front to back. It worked perfect all summer.

Joe,

Thank you very much for the offer to help. Did you happen to have the opportunity to check the spacing? Thanks!

Greg

mmandley
12-28-2015, 02:31 PM
Joe,

Thank you very much for the offer to help. Did you happen to have the opportunity to check the spacing? Thanks!

Greg

I think if you look at the back of the LSV Hull, it has two notches on the sides of the wake plate that have to have the bunks aligned to. This will give you the spacing you need.

As for height it depends on your boat house, how high the roof is, you will want to fold the tower down, if you plan to store it like that then measure from bottom of the hull to the top of the tower.

This is a picture of my Mojo but look at the bunks, those are the notches the bunks need to follow

http://i639.photobucket.com/albums/uu114/mmandley/Moomba%20Mojo/7148_XL_zpsca4edf65.jpg (http://s639.photobucket.com/user/mmandley/media/Moomba%20Mojo/7148_XL_zpsca4edf65.jpg.html)

jstenger
12-28-2015, 06:58 PM
I finally got out to measure mine. Inside bunk measurement is 34 1/2" back to front and they are 11" high back to front. They do need to be higher, but that was as high as they would go with the factory holes. I plan to drill a couple more holes to get them higher. I had to be careful driving onto the lift. The bunks were not high enough for the prop to clear the rear cross member.

http://i1217.photobucket.com/albums/dd382/Joestenger/2014%20Moomba%20LSV.jpg (http://s1217.photobucket.com/user/Joestenger/media/2014%20Moomba%20LSV.jpg.html)