View Full Version : Need a good bow roller
I did a lot of searching on the forum and online and couldn't find a good match. I want to get a good quality poly not rubber roller.
I measured the width of the mount and came up with 3.5" and no one seems to make one, choices are either 3" or 4". Is there a 3.5" or do you go with a 3" and not crank it down to let it spin?
mcdye
09-22-2015, 07:16 PM
The inner rubber on mine is 3" and then the outer bells. I have not had to replace one, but the Stoltz brand have been recommended on various sites. They can be purchased at various locations. http://www.stoltzind.com/bowstops.html
Agree on the Stoltz for sure but it is either 3 or 4 nothing between.
trayson
09-23-2015, 02:02 PM
what if you just got the 3" and put some spacers on either side so it didn't move laterally.
dusty2221
09-23-2015, 02:05 PM
If your trailer is a boatmate email Jerry your Vin and he can tell you which size you need.
Sent from my SAMSUNG-SM-G920A using Tapatalk
what if you just got the 3" and put some spacers on either side so it didn't move laterally.
Thought about that but was worried if there is a gap using a spacer the hull may have a place to get gouged if it slips between the roller and the bracket. I would need to have some kind of rubber spacer so the hull doesn't get damaged. Maybe a 4" and cut center part down by .5" on the band saw? That should work come to think of it.
If your trailer is a boatmate email Jerry your Vin and he can tell you which size you need.
Sent from my SAMSUNG-SM-G920A using Tapatalk
Thanks. I was on their site and they only have the 3 & 4". I may end up doing that or just cutting one down. My hull is really getting a lot of black crap on it. Seems to be getting worse.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.