Couple questions before heading to lake today.

[Henner]

My boat is at the lake house 3 hours away and before i head down there today i would like to stop and pick up some fuses but no sure which ones and what amp. My Phone chargers (cigarette lighters) stopped working when you turn on the ACC switch. Also the front ballast stopped draining, it fills just fine. Can anyone tell me which fuses i will need to fix both these problems. Boat is a 2006 LSV GG.

Thanks,

[jstenger]

Should be breakers, not fuses.

[trayson]

I have fuses for my factory ballast on my 2008 XLV. it had 3 amp fuses for the sprinkler valves and I think the drain pumps. I think 5 amps might have been there for the RULE fill pump. I blew my 3 amp fuses when I upgraded to the T1200 pumps so I put 5 amp fuses in there and have been fine so far. the fuses for the ballast were a PITA to find as they were hidden way up above the perfect pass module.

Not sure what amp the cig lighter is on. but why not just get the variety pack that has 5, 10, 15, and 20. should be good with all of those.

[Henner]

Ok i can do that but, are they the really small fuses or the normal size ones?

[trayson]

Sorry, this is undoubtedly way late, but the normal size blade fuses, not the mini ones.

[Henner]

Thanks trayson but i laid under the helm forever and can not find the fust block anywhere!!!!! I don't know if my sub box blocks it off but i tried to wiggle around everywhere with no luck.

[trayson]

Thanks trayson but i laid under the helm forever and can not find the fust block anywhere!!!!! I don't know if my sub box blocks it off but i tried to wiggle around everywhere with no luck.
It likewise took me forever to find mine. as I remember, it was above the sub box. above the horizontal piece of the steering cable. the perfect pass module is screwed to a panel in the center with the labling of the PP facing the port side of the boat. I think the fuse box for the ballast is on that same center panel, facing starboard or stern. It's hidden above and behind the engine/gauges wiring harness. I likewise searched like 5 different times until I found it.

I had to get a fuse in my fingers and pretty much stick my hand through a mess of wires in the wiring harness and was barely able to put a new fuse in by feel. There's NO way to read which fuse is for what pump. I just pulled fuses and replaced until things started working.