View Full Version : Wake Plate Electrical Side Wiring Diagram?
jnb0y
07-06-2015, 08:08 PM
Hey gang, I have a 2002 Outback LSV. My wake plate system is dead. Its stuck in the down position so the nose is down and so is the wake. Not hearing anything when I actuate the switch (pump or relay click) so I am going to do some troubleshooting. Anyone have a wiring diagram for this system? I see the wires coming out from behind the steering column switch and can probably check those, but thats about it.
jnb0y
07-06-2015, 08:34 PM
UPDATE: I checked the continuity of the wake plate switch and its good. Followed the wires down and under and the "middle" wire which I assume is power runs to a fuse. I opened the fuse cap and the fuse seems to be in good shape. The end of the wire that looks to connect to power was floating free and its not obvious where it should be connected. its not a spade connector, its a connector for a stud and nut or screw. I've attached a picture of the situation. Can anyone give me any guidance to what this should be attached to? I'm happy to change the connector in case this was someone's screw up before I had the boat.
https://goo.gl/photos/QBAiMy4AoyYquLLN6
parrothd
07-06-2015, 10:38 PM
Any switched power back there will work.. Maybe it was connected to one of the gauges..
jnb0y
07-07-2015, 12:03 AM
Cool, just wanted a second opinion before hooking it to power. Is your cavitation plate actuator on switched power? Mine wasn't switched, no need to have the key on to move the plate. Sounds like a good idea to change that. Thanks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.