wakeboard1026
05-27-2015, 09:51 AM
Hi All,
When the boat was on the lift, just high enough for waves to "slap" the bottom of the hull, I noticed water trickling in around the rudder port while I was doing an oil change.
I wasn't able to tell if it was coming in around the mounting plate or through the shaft of the rudder; so I will have to check again. But this brings me to my two questions:
Does anyone know what type of rudder seal/sealing a 2008 Moomba Mobius LSV uses, and how I can pack or tighten it to stop the leak?
Thanks in advance
When the boat was on the lift, just high enough for waves to "slap" the bottom of the hull, I noticed water trickling in around the rudder port while I was doing an oil change.
I wasn't able to tell if it was coming in around the mounting plate or through the shaft of the rudder; so I will have to check again. But this brings me to my two questions:
Does anyone know what type of rudder seal/sealing a 2008 Moomba Mobius LSV uses, and how I can pack or tighten it to stop the leak?
Thanks in advance