View Full Version : how to get to packing log
05-31-2006, 05:27 PM
I am trying to get to the packing log on our 2000 moomba kanga but I cannot figure out how to pull the floor plate out to get to it. It started to take on water at a good rate and it has never been checked or serviced before. Any Ideas would be greatly apprciated.
05-31-2006, 10:58 PM
You will first need to remove the engine cover, and then loosen the 4 screws on the plate 2 up near the motor and the other 2 are probably under the rear bench. You should be able to work the plate forward from there. (this is how it came out on my 01 Outback LS, I would imagine it is similar on the Kanga)
Good luck, E
Powered by vBulletin® Version 4.2.3 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.