PDA

View Full Version : '15 mondo bow bag in '14 problem install


hymanykd
05-02-2015, 03:48 PM
bought a piggy back kit for a moomba mondo to allow me to install a used factory (2015) bow bag. There are three mail quick connect fittings one on each leg and one in the front on the top. I have tried to pull one fitting to install a spare plug that have but it likes it is glued in place. What is the best way to plug the fitting or should I tee the two fill fitting together and run a hose around the bow to it.

Could someone tell me how the 15 is plumbed that may help as well or if anyone had a idea to get the quick connect fitting that would work as well
BrettLee3232
05-02-2015, 05:21 PM
The 15s have the 2 legs and the bow vent. I've seen someone epoxy a quick connect fitting to act as a plug. I haven't seen quick connect plugs at wakemakers.


Sent from my iPhone using Tapatalk
BrettLee3232
05-02-2015, 05:25 PM
http://images.tapatalk-cdn.com/15/05/02/66936cb1688563a41159f2e3b33cd18f.jpg

This is what Wolfeman used


Sent from my iPhone using Tapatalk
hymanykd
05-02-2015, 08:31 PM
http://images.tapatalk-cdn.com/15/05/02/66936cb1688563a41159f2e3b33cd18f.jpg

This is what Wolfeman used


Sent from my iPhone using Tapatalk

Is that silicone?
hymanykd
05-03-2015, 01:18 PM
Don't like just silcone or epoxy holding back 500lbs of water. So going to buy the quick connect fitting, 3" of hose and 1" pvc plug from Home Depot. Cost me $15.
wolfeman131
05-03-2015, 09:50 PM
I filled the plug with some 5 min epoxy I had lying around. Never had an issue.
jstenger
05-04-2015, 12:34 PM
Use a hair dryer to heat up the port on the bag of the quick connect that you want to remove and remove it. Wakemakers has a 'How to' on their website.
hymanykd
05-04-2015, 11:06 PM
Use a hair dryer to heat up the port on the bag of the quick connect that you want to remove and remove it. Wakemakers has a 'How to' on their website.


So I heated the fitting for about 15min... Still had to take pliers to loosen it but it did come loose, looks like some glue ended up on the first thread on the bag fitting and when I pulled the fitting it came with it and when I put the plug it wouldn't stop turning by hand... Wound up pvc cementing it in place. So that takes care of that!

Next question I have routing of the vent hose, no matter how I seem to run it is 6-9" short of a sweeping bend...mis there a certain way to run it or is it really tight?