Amp Setups

[mbusch5]

Curious how everyone set up thier amps. Just a board across the 2 support stringers in the storage area and attach them to that? Stereo should be coming in shortly so I'm trying to figure out my set up.

[jstenger]

2014 LSV. Javelin on top powering cabins and sub. XM30.2 on bottom powering four SXTQ9's.

http://i1217.photobucket.com/albums/dd382/Joestenger/20141223_153402.jpg (http://s1217.photobucket.com/user/Joestenger/media/20141223_153402.jpg.html)

[mmandley]

Old School Exile.

Harpoon to run 4 XM9s
800.4 to run 2 XM9s
800.4 to run 6 Exile cabins
2500.1 to power Exile Big 15 sub
Custom rack, amps have cut outs in the rear for cooling.
2 6V Golf Cart batteries to power it.

http://i639.photobucket.com/albums/uu114/mmandley/Stereo/Mojo%20Stereo/DSC_0950_zps60743138.jpg (http://s639.photobucket.com/user/mmandley/media/Stereo/Mojo%20Stereo/DSC_0950_zps60743138.jpg.html)

http://i639.photobucket.com/albums/uu114/mmandley/Stereo/Mojo%20Stereo/GosmsPhoto1361844339396_zps6eb13f5f.jpg (http://s639.photobucket.com/user/mmandley/media/Stereo/Mojo%20Stereo/GosmsPhoto1361844339396_zps6eb13f5f.jpg.html)

[mbusch5]

Nice setups....very clean...so what did you attach your boards to and how?

[ian ashton]

21227

Xi800.4 power 6 SX65-Ms

2 XM30.2's - one powering a pair of XM9s, the other power a pair of SXT9s

Xi1500.1 powering 2 Kicker S10L7s (this is not pictured, it's mounted to the back of the bow seat)


My boat is .375" Starboard, and I just screwed it flat to the air intake tunnel. Hasn't moved yet :)

[jstenger]

The Moomba's come from the factory with a pair of glassed in and carpeted braces behind the observer seat along the port side wall. That is where the stock amp board screws too. Most people do the same when using different or larger boards. Simply screw through the board and into the braces with four to six #12 X 1.5" stainless screws.

[mbusch5]

The Moomba's come from the factory with a pair of glassed in and carpeted braces behind the observer seat along the port side wall. That is where the stock amp board screws too. Most people do the same when using different or larger boards. Simply screw through the board and into the braces with four to six #12 X 1.5" stainless screws.


Thanks, that's what I was thinking, just wanted to make sure before I started driving screws.