View Full Version : operating temp?
motosno963
06-27-2014, 04:59 PM
What's a good operating temp for the outback. Seems like mines running around 180-190 and when I grab the rubber hoses that the water runs through, it feels like there's barley anything running through the hoses. But if I do the fake a lake in my drive way it spits out a good amount of water..
jester
06-27-2014, 06:14 PM
That seams a little high. I run about 160. I would check your impeller and if you have a strainer that too. You have to remember that on a fake a lake you are forcing water into the system but at the lake the impeller is sucking water from the lake and putting it into the system.
uniwarking
06-27-2014, 08:09 PM
Mine runs around 170... Not sure how accurate the gauge is though.
Sent from my iPhone using Tapatalk
spratt25
06-27-2014, 10:33 PM
My 98 runs about 180 to 190 brand new impeller because I was a little concerned but seems to be ok
motosno963
06-28-2014, 12:44 AM
ok..i just replaced the whole housing and impeller 2 summers ago..
Stazi
06-28-2014, 07:20 AM
What about the actual water pump on the motor? Have you ever replaced that?
papou
06-28-2014, 01:21 PM
Do you have a strainer ? If so be sure the threaded fitting are sealed and do not twist ,the pump will pull air in and cause this issue , i had this problem on my 05 LS
Gabbyg88
06-28-2014, 06:56 PM
Mines runs 180 - 185
bergermaister
06-28-2014, 08:22 PM
Just had a thermostat go bad after one season only. Rare but it can happen.
It's basically just a SBC high flow style. Typically they are 160 degree so your operating range shouldn't be too far from that.
motosno963
06-28-2014, 09:04 PM
Do you have a strainer ? If so be sure the threaded fitting are sealed and do not twist ,the pump will pull air in and cause this issue , i had this problem on my 05 LS
I have a strainer and I tighten it hand tight so I dont over tighten it and crack it. I replaced the thermostat like summers ago but I forgot what temp setting it was for..but I mean you can still run one without a stat and it would run cooler.. also I have seen some of the pumps themselves on eBay for like 80$ I think..aglfter I do the oil and get a new deep cycle batt for the boat I'll maybe pick one of those up
papou
06-29-2014, 09:16 PM
I have a strainer and I tighten it hand tight so I dont over tighten it and crack it. I replaced the thermostat like summers ago but I forgot what temp setting it was for..but I mean you can still run one without a stat and it would run cooler.. also I have seen some of the pumps themselves on eBay for like 80$ I think..aglfter I do the oil and get a new deep cycle batt for the boat I'll maybe pick one of those up
I didn't mean the strainer cup ,i meant the threaded input and output fittings, they should be sealed and not twist or the pump will pull air in , giving you a high temp reading , heater not working at low rpm , my 2012 LSV was showing symptoms and sure enough it was the fittings as well.
motosno963
06-30-2014, 07:45 PM
Ohh the input and output on the strainer itself?. Maybe I'll take them off, inspect them and put some thread tape on them
liquid_acid
07-01-2014, 11:14 PM
My 98' outback is usually around 170. I replaced the pump and impeller this past winter. Sometimes when I'm at idle it might go up a bit past 175 but not much. As I throttle even just a little bit, water is pulled through and cooled.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.