pictures of reinforced locker walls please

[Brayden]

Ok, I have searched the forums and I understand the importance of reinforcing the locker walls for the 1100lb bags....however i just can't seem to upload the pictures.....I am a visual guy can someone send some pictures for me of the finished product.....
thx

[moombadaze]

heres mine
https://forum.moomba.com/showthread.php?19478-Daze-s-2013-mod-thread

[jmvotto]

I did mine like daze, attached to the door, but instead of doing 4 vertical brackets , I did two "vee" shaped to cover the door with less aluminum.

[muehlcj]

Here is mine: 17813

[Brayden]

I am not very mechanically inclined and it freaks me out drilling holes anywhere near the bottom of the boat...so when i put the bottom bracket on i use 1 inch screws and I will have no problem? do i need to put the bottom bracket o or can i just reinforce wall?
thx for pics its greatly appreciated!

[lsvboombox]

http://i73.photobucket.com/albums/i205/chopsuey-pics/2011-02-12_13-05-06_249.jpg
http://i73.photobucket.com/albums/i205/chopsuey-pics/2011-02-12_13-04-45_765.jpg

I ended up removing that hinge in the middle and using a L bracket on the motor side so it doesnt push in.

Its hard enough to work in the motor well so i elected to mount something on the doors and not the aluminum motor frame

[Brayden]

great thanks....do you remember what size screws you went with to mount the l bracket? 1 inch?
thx

[lsvboombox]

great thanks....do you remember what size screws you went with to mount the l bracket? 1 inch?
thx

i think 1 inch. I pulled one out of the existing hinge on the floor and used the same

[tgoody14]

17831
17834
17835
17836

[E4NASH]

Haven't done mine yet and quite frankly I haven't seen the need to yet either...

[tgoody14]

Haven't done mine yet and quite frankly I haven't seen the need to yet either...

That's good to know!

[Wax]

Haven't done mine yet and quite frankly I haven't seen the need to yet either...

Based on E4NASH's similar comment on a previous thread, I chose to try my 1100 bag without reinforcement. I also have not yet seen a need for the reinforcement. However, I did remove the hydraulic lift and bracket on the 1100 side (I have 650 in other side) and I fill that sucker up all the way, the lid is lifted up a couple inches when I'm done filling sometimes lol!

If you haven't lengthened your fill hose yet (if you have to on a 2011, mine's a 2006), I used stuff from Lowe's to extend my fill hose on both sides; it was $11 for materials and took about 5 minutes to do.