View Full Version : 13 LSV ZLD mouting
lewisb13
04-20-2013, 01:59 PM
So here's how I mounted my zld in case anyone is doing this is the future. Just epoxied some erector set pieces on there. Used needle nose vise grips to hold while the epoxy was setting up.
17191
moombadaze
04-20-2013, 08:42 PM
I basically did the same, ran some short screws into the backside of the dash
ian ashton
04-20-2013, 09:02 PM
I basically did the same, ran some short screws into the backside of the dash
That's how I did it on the LSV. Not sure where I want or how I'll mount the ZLD on my V.
http://img.tapatalk.com/d/13/04/21/umemyted.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.