Light Bar wiring help

[amonteroman]

I am going to attempt wire a 6 light bar, (home made) and I really dont know much about this sort of thing. I have an 04 Outback, it looks like there are 2 acc. switches that are not being used for anything. I think I might be able to pull this off but my main concern is, can I wire up all 6 lights, (55watts each) to one switch, or will that blow the breaker? I also need to find a connector to go through the hull that can handle all of the wiring, unless I can connect all of the lights together inside the light bar and just run 1 set of wires down the tower and use the vacant side of the connector that powers the tower navigation light. Thanks in advance for any help.

[Flatwater]

You will need to use relays to switch all the power , the ACC switch on the dash will turn on the relays. Don't forget to use the correct size fuse. I would run more wire to allow you some flexability on which lights you want on. I use connectors made by Neutik sp? which work well and have 4 and 8 pin connectors. Check out www.diytowers.com for more info. Post pics when done ok